Abstract:As is well known, resin and asphaltene greatly increase the viscosity of the oil, which causes difficulty for heavy oil to flow and to be displaced. Therefore, reducing the viscosity of heavy oil effectively is the key to enhance oil recovery. A hyperbranched copolymer named as HVR grafted with hydrophilic surfactant monomers, was synthesized and evaluated in this paper as an alternative to reduce the offshore heavy oil viscosity. The synthesis method of HVR through free-radical copolymerizing using the third generation polyamidoamine dendrimer, acrylamide, acrylic acid and surfactant monomers in deionized water was detailed in this paper. Thereupon the characterization of HVR were described by Fourier transform infrared spectroscopy and 1H nuclear magnetic resonance spectroscopy. The physical properties of HVR solution including apparent viscosity, oil viscosity reducing ability, interfacial tension were comprehensively studied. Otherwise the effect of HVR on sheet structure of asphaltene aggregate and asphaltene aggregation inhibition-dispersion activity were measured by X-ray diffraction and ultraviolet–visible spectrophotometer, respectively. The results indicate that apparent viscosities of HVR solution is relatively not high. For example, after shearing with a Waring blender at 3500 rpm for 20 s, the viscosity of 2500 ppm HVR solution is only 22.7 cP. However, the HVR solution has a relatively high viscosity remaining rate, which is approximately 58%. On the other hand, HVR solution has a good viscosity reducing ability on heavy oil. For the oil viscosities from 350 cP to 500 cP, the viscosity reduction rate of HVR at 2000 ppm is approximately 97% under the oil-water ratio of 3:7. In addition, the oil-water interfacial tension can be reduced by HVR solution at the concentration of 2500 ppm to 1.61 × 10−2 mN m−1. Comparing the asphaltene aggregates after interacting with HPAM and HVR, it illustrates that the layer spacing, interchain distance and diameter of the aromatic sheets are lager if interacting with HVR; meanwhile height of the aromatic clusters and effective number of aromatic sheets are smaller due to the reaction with HVR. In addition, if compared with the asphaltene treated by HPAM, with the increase of HVR concentration, the absorbance of asphaltene in toluene treated by HVR solution decreased significantly. Overall, this new hyperbranched copolymer shows potential for applications in heavy oil viscosity reduction.

Preparation and controllable heavy oil viscosity reduction performance of pH-responsive star block copolymers

JIN Zhiyuan1,2, SHAN Guorong2,3, PAN Pengju2,3

Synthesis and Molecular Dynamics Simulation of Amphiphilic Low Molecular Weight Polymer Viscosity Reducer for Heavy Oil Cold Recovery

Viscosity Reduction Process of Heavy Oil by Catalytic Co-Pyrolysis with Sawdust

Double Alkyl Chain Copolymers As Flow Improvers for Heavy Oil

Synthesis and Mechanistic Investigation of an Amphiphilic Polymer in Enhancing Extra-Heavy Oil Recovery via Viscosity Reduction

Synthesis and application of amphiphilic copolymer as demulsifier for super heavy oil emulsions

Effect of molecular weight on the properties of water-soluble terpolymers for heavy oil viscosity reduction

Quadripolymers As Viscosity Reducers for Heavy Oil

Preparation and evaluation of hydroxyethyl cellulose–based functional polymer for highly efficient utilization of heavy oil under the harsh reservoir environments

Polymer-Coated Nanoparticles for Reversible Emulsification and Recovery of Heavy Oil

Synthesis of Polycarboxylate Viscosity Reducer and the Effect of Different Chain Lengths of Polyether on Viscosity Reduction of Heavy Oil

Molecular Design of the Amphiphilic Polymer as a Viscosity Reducer for Heavy Crude Oil: From Mesoscopic to Atomic Scale

Preparation and Performance Evaluation of Amphiphilic Polymers for Enhanced Heavy Oil Recovery

A novel active amphiphilic polymer for enhancing heavy oil recovery: Synthesis, characterization and mechanism

Developing New Recyclable and pH-Sensitive Amphiphile for Heavy Oil Emulsion and Demulsification: A Molecular Dynamics Study

Realizing the Rapid Release of Drag Reducers via pH-Induced Oil Phase Transition of Inverse Emulsion

Design, synthesis and properties evaluation of emulsified viscosity reducers with temperature tolerance and salt resistance for heavy oil

Synthesis and evaluation of a hyperbranched copolymer as viscosity reducer for offshore heavy oil

Realizing the Efficient Dissolution of Drag Reducer upon pH-Induced Demulsification of Inverse Polymer Emulsion

Biphasic control strategy of polymers and nanoparticles for viscous oil removal and molecular release: Synthesis, mechanism and applications