Optimal selection of working fluid for enhanced geothermal systems: A comparative analysis of supercritical carbon dioxide and water under various reservoir and extraction conditions

Jiajie Yang,J.G. Wang,Wei Liang,Peibo Li,Rui Sun
DOI: https://doi.org/10.1016/j.applthermaleng.2024.122947
IF: 6.4
2024-03-20
Applied Thermal Engineering
Abstract:Geothermal energy is widely recognized as a highly promising clean energy due to its abundant reserve and low carbon footprint. The extraction of geothermal energy does not only depend on the stimulated reservoir volume but also depends on working fluid. Water (H 2 O) is usually used as the working fluid but carbon dioxide (CO 2 ) can be a good alterative working fluid. However, the suitable conditions and extraction efficiency of CO 2 compared to H 2 O have been unclear. This study compares the efficiency of heat extraction from an enhanced geothermal system (EGS) by using supercritical CO 2 or H 2 O as working fluid and identifies the favorable or unfavorable conditions for each working fluid. Firstly, a thermal–hydraulic-mechanical (THM) coupling model is established and validated by two analytical solutions. Secondly, the performance of a typical EGS is evaluated with four indicators. Finally, a comparative analysis for heat extraction efficiency is performed with CO 2 and H 2 O under different reservoir and extraction conditions. The analysis results reveal that under most conditions, the heat extraction rate of CO 2 is 1.4–2.2 times that of H 2 O in the early stage and the final cumulative heat recovery is 0.8–1.9 times that of H 2 O. CO 2 is more efficient in reservoirs with low permeability (no more than 2.5 mD), low injection pressure (no more than 28 MPa, or 8 MPa for pressure difference) and low temperature (no more than 35°C), while H 2 O performs better in reservoirs with high permeability (no less than 5.0 mD), high injection pressure (no less than 32 MPa, or 12 MPa for pressure difference) and high injection temperature (no less than 40°C). Furthermore, more pronounced thermal breakthrough and inadequate heat extraction are observed in reservoirs with high porosity and high injection pressure when CO 2 is the working fluid.
energy & fuels,engineering, mechanical,thermodynamics,mechanics
What problem does this paper attempt to address?