Abstract:Historical heritage pieces allow a better comprehension of the characteristics of different civilizations over time. The characterization of such pieces is of paramount importance for their preservation. Energy‐dispersive X‐ray fluorescence (EDXRF) is recommended for this application, mostly because it is non‐destructive and the equipment is portable. However, one of its limitations is the difficulty in separating the signal from the substrate and the coating of multilayered samples, as it does not provide depth resolution. This project investigates the application of EDXRF in the characterization of metallic coatings, in the context of historical heritage. The elemental concentration of electrodeposited Ni coatings onto carbon steel substrates was obtained from EDXRF analyses. The relationship between the layer thickness and the variation of the Kα/Kβ intensity ratio of nickel peaks was exploited and the thicknesses of the coatings were estimated through EDXRF measurements. For comparison, particle‐induced x‐ray emission spectroscopy and scanning electron microscopy of the cross‐section were employed, providing a depth profile of the coatings. The estimated thicknesses from EDXRF analysis were comparable to those observed in the microscopy images for thinner films (up to 8 μm). On the other hand, for thicker films, the thicknesses were underestimated, due to the technique's depth limit and matrix effects, as secondary absorption. Despite these limitations, EDXRF remains valuable for evaluating cultural heritage pieces, often providing sufficient information to address authenticity concerns or to guide restoration processes. A case study was also performed to apply the methodology discussed on historical metallic pieces.

On the measurement by EDX of diffusion profiles of Ni/Cu assemblies

Analytic procedure for the evaluation of copper intermetallic diffusion in electroplated gold coatings with energy dispersive X-ray microanalysis

Investigation of the X‐ray fluorescence technique in the characterization of Ni coatings applied to historical heritage studies

An experimental estimation method of diffusion coefficients in ternary and multicomponent systems from a single diffusion profile

An Experimental Estimation Method of Diffusion Coefficients in Ternary and Multicomponent Systems from a Single Diffusion Couple Profile

Mesoscopic quantitative chemical analyses using STEM-EDX in current and next generation polycrystalline Ni-based superalloys

On the analysis of composition profiles in binary diffusion couples: systems with a strong compositional dependence of the interdiffusion coefficient

Interdiffusion in the FCC-structured Al-Co-Cr-Fe-Ni High Entropy Alloys: Experimental Studies and Numerical Simulations

Interdiffusion and atomic mobility in FCC Ag–Cu–Ni alloys

Atomic diffusion across Ni50Ti50—Cu explosive welding interface: Diffusion layer thickness and atomic concentration distribution

A Method to Measure the Diffusion Coefficient in Liquids

A liquid metal diffusion measurement technique integrating the x-ray radiography and multi-slice sliding cell

Determination of copper nanoparticle size distributions with total reflection X-ray fluorescence spectroscopy

Automated Development of an Accurate Diffusion Database in Fcc AlCoCrFeNi High-Entropy Alloys from a Big Dataset of Composition Profiles

Computed depth profile method of X-ray diffraction and its application to Ni/Pd films

The measurement approach of X-ray residual stress in Fe-Ni alloy with different textures

Characterization of single-atom catalysts by EELS and EDX spectroscopy

In-situ X-ray diffraction study on dealloying: A scenario of a Cu90Au10 alloy

Diffusion NMR for Measuring Dynamic Ligand Exchange on Colloidal Nanocrystals

Why is EXAFS analysis for multicomponent metals so hard? Challenges and opportunities for measuring ordering in complex concentrated alloys using x-ray absorption spectroscopy

Auger Depth Profile Studies of Diffusion at Iron Phthalocyanine/Copper Phthalocyanine Interfaces