Abstract:With the development of automotive technology and the increase in the performance of the moving parts in the car, the most important of which is the engine and gearbox. Where companies are working to increase the sound insulation of the movement of these parts outside and reduce the noise and stress generated because of movement, to study these noises and stresses, and to know the vibrations that give a high sound rate and wave pressure. Where it worked on a standard gearbox and simulated the movement of gears. To find out the stresses that are calculated because of this movement, the external stress caused by this movement of the gears, as well as the speed of the gears in the case of rotation, is also known. The results proved the contact areas of the main lip on the outer cover are greatly affected during the gearbox rotation process and also at high vibrations. The effect of vibrations and the Hertzian rate is significantly affected by it. At frequencies that reached 1500 Hz the value of stresses and deformation was relatively large. The acceleration and due to the different gear teeth, the acceleration value in this case was 3000 m/s2. The maximum value of shear stresses reached 9.5×104 Pa at the frequency between 1500 and 2000 Hz. The value of the vibration 1500 Hz is the highest value that achieved high noise as it was 112 dB, which is a 112 dB higher than the rest of the vibrations. The achievement of the condition of the presence of large noise when vibration 1500 Hz is reached is achieved by analyzing the noise produced by a car’s gearbox at that level. The amount of noise pressure and its wave through the outside air of the gearbox, where the amount of wave pressure of the noise reached a maximum value of 400 Pa and the lowest value ‐ 500 Pa.

A quantum-theoretical approach to the phenomenon of directed mutations in bacteria

Dispersion of critical rotational speeds of gearbox: effect of bearings stiffnesses

Vibro-acoustic propagation of gear dynamics in a gear-bearing-housing system

Effect of an original gear mesh modelling on the modal behaviour of gear transmission

Acoustic-vibration analysis of the gear-bearing-housing coupled system

Stochastic dynamics of a finite-size spiking neural network

Vibro-acoustic characteristics of gear-rotor-bearing coupled system under multi-source excitation

Modélisation et analyse de l'erreur statique de transmission d'un engrenage. Influence des déformations des roues et interactions entre les couples de dents en prise

Evaluating lightweight gear transmission error: a novel nonlinear finite element approach using direct constraint contact algorithm

OPTIMIZATION OF COMPOUND PLANETARY GEAR TRAIN BY IMPROVED MESH STIFFNESS APPROACH

Variability of Critical Rotational Speeds of Gearbox by Misalignement and Manufacturing Errors

An Integrative Computational Method for Gearbox Diagnosis

Effect of the Tooth Surface Waviness on the Dynamics and Structure-Borne Noise of a Spur Gear Pair

A numerical implementation study of the stresses and noise generated by the gear engagement in the gearbox

Dynamic modelling of the gear system under non-stationary conditions using the iterative convergence of the tooth mesh stiffness

Influence of Tooth Pitting and Cracking on Gear Meshing Stiffness and Dynamic Response of Wind Turbine Gearbox

Low noise optimization of two-stage gearbox housing structure based on acoustic contribution analysis and topology optimization

Research of the Torsion Stiffness of Involute Gear Transmission

Dynamic Model and Numerical Simulation of Multi-stage gear-rotor-bearing System

Dynamic modeling of spur gear system considering the coupling effect between bearing deflection and gear mesh stiffness

Dynamic Modelling and Parametric Optimisation of Vibro-Acoustic Responses for Power-Split Hybrid Transmission