CW/Pulsed H− Ion Beam Generation with PKU Cs-free 2.45 GHz Microwave Driven Ion Source
S. X. Peng,H. T. Ren,Y. Xu,T. Zhang,A. L. Zhang,J. F. Zhang,J. Zhao,Z. Y. Guo,J. E. Chen
DOI: https://doi.org/10.1063/1.4916485
2015-01-01
Abstract:Circular accelerators used for positron emission tomography (PET, i.e. accelerator used for make radio isotopes) need several inA of CW H- ion beam for their routine operation. Other facilities, like Space Radio-Environment Simulate Assembly (SPRESA), require less than 10 mA pulsed mode it beam. Caesium free negative hydrogen ion source is a good choice for those facilities because of its compact structure, easy operation and low cost. Up to now, there is no it source able to produce very intense H- beams with important variation of the duty factor[1]. Recently, a new version of 2.45 OHz microwave it ion source was designed at PKU, based on lessons learnt from the previous one. This non cesiated source is very compact thanks to its permanent magnet configuration. Special attention was paid on the design of the discharge chamber structure, electron dumping and extraction system. Source test to produce Ef ion beams in pulsed and CW mode was carried out on PKU ion source test bench. In CW mode, a 10.8 mA/30keV H- beam with rms emittance about 0.16 minmnnrad has been obtained with only 500 W rf power. The power efficiency reaches 21 mA/kW. In pulsed mode with duty factor of 10% (100Hz/1ms), this compact source can easily deliver 20 mA H- ion beam at 35 keV with rms emittance about 0.2 pi.mm.mrad when RE power is set at 2.2 kW (peak power). Several hour successive running operation in both modes and totaling more than 200 hours proves its high quality. The outside dimension of this new H- source body is phi 116 mm x 124 mm, and the entire H- source infrastructure, including rf matching section, plasma chamber and extraction system, is phi 310 x180 nun The high voltage region is limited with in a phi 310 nun x 230 nun diagram. Details are given in this paper.