Abstract:To achieve high-quality chemical vapor deposition of monolayer graphene electrodes (CVD-MG), appropriate characterization at each fabrication step is essential. In this article, (1) Raman spectroscopy/microscopy are employed to unravel the contact effect between the CVD-MG and Cu foil in suspended/supported formation. (2) The Surface-Enhanced Raman spectroscopy (SERS) system is described, unveiling the presence of a z-directional radial breathing-like mode (RBLM) around 150 cm−1, which matches the Raman shift of the radial breathing mode (RBM) from single-walled carbon nanotubes (SWCNTs) around 150 cm−1. This result indicates the CVD-MG located between the Au NPs and Au film is not flat but comprises heterogeneous protrusions of some domains along the z-axis. Consequently, the degree of carrier mobility can be influenced, as the protruding domains result in lower carrier mobility due to flexural phonon–electron scattering. A strongly enhanced G-peak domain, ascribed to the presence of scrolled graphene nanoribbons (sGNRs), was observed, and there remains the possibility for the fabrication of sGNRs as sources of open bandgap devices. (3) Electrostatic force microscopy (EFM) is used for the measurement of surface charge distribution of graphene at the nanoscale and is crucial in substantiating the electrical performance of CVD-MG, which was influenced by the surface structure of the Cu foil. The ripple (RP) structures were determined using EFM correlated with Raman spectroscopy, exhibiting a higher tapping amplitude which was observed with structurally stable and hydrophobic RPs with a threading type than surrounding RPs. (4) To reduce the RP density and height, a plausible fabrication could be developed that controls the electrical properties of the CVD-MG by tuning the cooling rate.

Characterization of heterogeneity of CVD graphene on copper foil by scanning probe microscopy and Raman spectroscopy

Varying Electronic Coupling at Graphene-Copper Interfaces Probed with Raman Spectroscopy

Strain analysis of plasma CVD graphene for roll-to-roll production by scanning transmission electron microscopy and Raman spectroscopy

The influence of copper substrate temperature on the wettability of graphene coating

Electron Transport in Graphene-Versus Al/Pd-Coated Thin Cu Films with Low-Surface Roughness: A First Principles Study.

An Investigation of Electric Resistance of Graphene-Coated Copper Thin Film from First Principles

Synthesis of High-Quality Monolayer and Bilayer Graphene on Copper Using Chemical Vapor Deposition

First Principles Calculation of Effect of Graphene Coating on Transmission Coefficient of Cu Thin Film with Low Surface Roughness

Non-destructive and Rapid Evaluation of CVD Graphene by Dark Field Optical Microscopy

Synthesis and characterization of graphene on copper foil via atmospheric pressure chemical vapor deposition method and its impact on electrical properties

Electrical Resistivity Measurements of Surface-Coated Copper Foils

Homogeneous Optical and Electronic Properties of Graphene Due to the Suppression of Multilayer Patches During Cvd on Copper Foils

Direct observation of graphene growth and associated copper substrate dynamics by in situ scanning electron microscopy.

Atomic and electronic structure of a copper/graphene interface as prepared and 1.5 years after

Nano-Physical Characterization of Chemical Vapor Deposition-Grown Monolayer Graphene for High Performance Electrode: Raman, Surface-Enhanced Raman Spectroscopy, and Electrostatic Force Microscopy Studies

Surface morphology and associated high temperature evolution of copper covered with vapor deposited graphene

Direct Identification of Multilayer Graphene Stacks on Copper by Optical Microscopy

Low-temperature quantum transport in CVD-grown single crystal graphene

A facile method to observe graphene growth on copper foil

Electronic Structure Study of Ordering and Interfacial Interaction in Graphene/cu Composites

The differences of physicochemical characteristics of graphene-like nanomaterials directly grown on copper foil and quartz substrate in chemical vapor deposition (CVD)