Abstract:Ash aerosol and ash deposit formation during oxy-coal combustion were explored through experiments in a self-sustained 100kW rated down-fired oxy-fuel combustor. Inlet oxidant conditions consisted of 50% inlet oxygen with CO2 (hereafter denoted as OXY50 conditions). A Berner low pressure impactor (BLPI), a scanning mobility particle sizer (SMPS), and an aerodynamic particle sizer (APS) were used to obtain size segregated ash aerosol samples and to determine the particle size distributions (PSD). A novel surface temperature controlled ash deposition probe system that allowed inside and outside deposits to be separated was used to collect the ash deposits. The ash aerosol PSDs given by the BLPI and those produced by SMPS/APS were consistent with each other. Data suggested that oxy-coal combustion under these conditions did not change the formation mechanisms controlling the bulk ash aerosol composition, but it did increase the formation of ultra-fine particles initially formed through metal vaporization, due to increased vaporization of silicon at the higher combustion temperature. The smaller particles contained within the deposits had higher Si and lower Na and S concentrations under OXY50 conditions than for air combustion. Moreover, the ash aerosol composition for particle sizes less than 2.4μm was related to the composition of the inside deposits. A higher Na in the ash aerosol resulted in higher Na in inside deposits with comparable absolute Na concentrations in both those aerosol particles and those inside deposits particles. The contribution of S and Si to the inside deposits showed that S in the vaporization modes together with Si in the ultrafine vaporization mode, contributed significantly to the composition of the inside deposits. These results provided direct evidence that prediction of the chemistry of the initial deposit layer (but not of the bulk deposits) required knowledge of the size segregated chemistry of the ash aerosol.

From ashes to answers: decoding acoustically agglomerated soot particle signatures

A Slight Smoke Perceptual Network.

Growth of Polycyclic Aromatic Hydrocarbon and Soot Inception by in silico Simulation

Quantifying the Fractal Dimension and Morphology of Individual Atmospheric Soot Aggregates

Advanced characterization of soot precursors via excitation emission matrices fluorescence spectroscopy and molecular modeling

Reconstructing Soot Fields in Acoustically Forced Laminar Sooting Flames Using Physics-Informed Machine Learning Models

Predicting 3D distribution of soot particle from luminosity of turbulent flame based on conditional-generative adversarial networks

Morphology, Composition, and Mixing State of Primary Particles from Combustion Sources — Crop Residue, Wood, and Solid Waste

Elucidating the polycyclic aromatic hydrocarbons involved in soot inception

Characterizing soot in TEM images using a convolutional neural network

The source identification and classification study of soot after combustion

Morphology and Fractal Dimension of Size-Resolved Soot Particles Emitted from Combustion Sources

Microphysical Properties of Atmospheric Soot and Organic Particles: Measurements, Modeling, and Impacts

Ash Aerosol Formation from Oxy-Coal Combustion and Its Relation to Ash Deposit Chemistry

Learning Class-Specific Spectral Patterns to Improve Deep Learning Based Scene-Level Fire Smoke Detection from Multi-Spectral Satellite Imagery

Early Smoke Recognition Algorithm for Forest Fires

A Machine Learning Based Approach for Statistical Analysis of Detonation Cells from Soot Foils

Visual Smoke Detection Based on Ensemble Deep CNNs.

A Mass Spectrometry-Machine Learning Approach for Detecting Volatile Organic Compound Emissions for Early Fire Detection

Predicting aggregation rates of polycyclic aromatics through machine learning

Embedded Spatial–Temporal Convolutional Neural Network Based on Scattered Light Signals for Fire and Interferential Aerosol Classification