Abstract:In the framework of a deep geological radioactive waste disposal in France, the hydromechanical properties of the designated host rock, the Callovo-Oxfordian claystone (COx), are investigated in laboratory tests. Experiments presented in this study are carried out to determine several coefficients required within a transversely isotropic material model. They include isotropic compression tests, pore pressure tests, and deviatoric loading tests parallel and perpendicular to the bedding plane. We emphasize the adapted experimental devices and testing procedures, necessary to detect small strains under high pressures, on a material, which is sensitive to water and has a very low permeability. In particular, we discovered a significant decrease of elastic stiffness with decreasing effective stress, which was observed to be reversible. In both isotropic and deviatoric tests, a notable anisotropic strain response was found. The Young modulus parallel to bedding was about 1.8 times higher than the one perpendicular to the bedding plane. A notably low Poisson ratio perpendicular to the bedding plane with values between 0.1 and 0.2 was evidenced. While the anisotropy of the back-calculated Biot coefficient was found to be low, a significant anisotropy of the Skempton's coefficient was computed. The performed experiments provide an overdetermined set of material parameters at different stress levels. Using all determined parameters in a least square error regression scheme, seven independent elastic coefficients and their effective stress dependency are characterized. Parameters measured under isotropic loading are well represented by this set of coefficients, while the poroelastic framework with isotropic stress dependency is not sufficient to describe laboratory findings from triaxial loading.

p=constant compression on loose Hostun sand: The case of an anisotropic response

Effects of Initial Static Shear on Cyclic Resistance and Pore Pressure Generation of Saturated Sand

Energy-Based Approach to Quantify Cyclic Resistance and Pore Pressure Generation in Anisotropically Consolidated Sand

Hypoplastic Modeling of Anisotropic Sand Behavior Accounting for Rotation of Principal Stress Direction

Impact of Static Preshearing on Undrained Anisotropy and Shear Characteristics of Sand

Non-coaxial hypoplastic model for sand with evolving fabric anisotropy including non-proportional loading

Advanced laboratory investigation of axial cyclic loading in silica sands

Experimental Test of the validity of "Isotropic" Approximation for the Mechanical Behaviour of Clay

Pure elastic stiffness of sand represented by response envelopes derived from cyclic triaxial tests with local strain measurements

Transversely Isotropic Poroelastic Behaviour of the Callovo-Oxfordian Claystone: A Set of Stress-Dependent Parameters

Experimental Research On Behaviors Of Saturated Loose Sand Subjected To Oblique Ellipse Stress Path

Small Strain Path-Dependent Stiffness of Toyoura Sand: Laboratory Measurement and Numerical Implementation

From the stress response function (back) to the sandpile `dip'

EXPERIMENTAL STUDY OF EARTH PRESSURE FOR ANISOTROPIC SAND CONSIDERING LATERAL DISPLACEMENT

Stress Propagation and Arching in Static Sandpiles

Determination of hydro-mechanical Properties of Sand

Evaluation of a simplified soil constitutive model considering implied strength and pore-water pressure generation for one-dimensional (1D) seismic site response

Experimental Study on Asymptotic Behaviour of Anisotropic Sand

Stress Propagation in Sand

Experimental Approach for Assessing Dissipated Excess Pore Pressure Induced Settlement

Effect of Anisotropic Stress State on Elastic Shear Stiffness of Sand–Silt Mixture