Abstract:The design of working fluid (WF) tubes inside the phase change material (PCM) based thermal storage unit plays a significant role in determining the temperature distribution, as well as the melting and solidification rate of PCM. A uniform temperature inside the PCM volume can be ensured by considering a well distributed WF tubes structure in it. Previous research by authors introduced a PCM integrated tubular solar receiver for small-scale dish-micro gas turbine system. This receiver has U-tubes structure in the PCM volume and features a conical shaped cavity at the receiver aperture. These solar receiver are designed to store short-term (15–20 min) energy in order to mitigate the impact of natural solar fluctuations. In this study, a novel tube structure consisting of double-helical tubes with inlet and outlet sections were utilized in the solar receiver to have better distribution of WF tubes within the PCM volume, resulting in a more uniform temperature distribution. The solar receiver includes six such tubes, wrapped around the conical cavity, with the helix diameter gradually decreasing from the first to the sixth tube while maintaining an equal distance from the cavity wall. Detailed 3D modelling using ANSYS Fluent 2022 R1 was conducted to investigate the behavior and thermal capacity of the storage system. The study commenced with a steady-state charging (melting) phase under a constant solar flux. Subsequently, considering the interruption in solar flux, the transient discharging (solidification) phase was initiated after the steady-state charging phase. The solidification behavior of the PCM and outlet air temperature were analyzed after each time step. The results demonstrated a favorable behavior of the double-helical tube solar receiver, with a PCM liquid fraction of approximately 28 % after 30 mins of discharging phase, while the outlet air temperature at this point reached approximately 1000 K. The outlet air temperature remained stable, decreasing only 50 K during the discharging phase from 7 to 30 min. However, these tubes exhibited a higher pressure drop due to some sharp bends. Furthermore, the temperature distribution on the conical cavity was analyzed.

Design and analysis of PCM integrated solar receiver with double-helical tube structure

Investigation on the Melting Performance of a Phase Change Material Based on a Shell-and-Tube Thermal Energy Storage Unit with a Rectangular Fin Configuration

Investigation of thermal performance and charging/discharging characteristics of finned coaxial evacuated tube collector filled with phase change material

An experimental study of melting behavior of the phase change material in cylindrical capsules for thermal energy storage

Experimental and numerical analysis of hybrid nano-enhanced phase change material (PCM) based flat plate solar collector

Optimization of the thermal performance of a lobed triplex-tube solar thermal storage system equipped with a phase change material

Optimization of thermal efficiency on solar parabolic collectors using phase change materials - experimental and numerical study

Performance investigation on flat plate solar water collector using a hybrid nano-enhanced phase change material (PCM)

Optimization and thermal performance of U-type evacuated tube solar collector filled with phase change material

Investigation on Phase Change Behavior of Paraffin Phase Change Material in a Spherical Capsule for Solar Thermal Storage Units

CFD simulation of a solar collector integrated with PCM thermal storage

Analysis of micro heat pipe array based evacuated tube solar water heater integrated with an energy storage system for improved thermal performance

Study of the Phase-Change Thermal-Storage Characteristics of a Solar Collector

A novel composite PCM for seasonal thermal energy storage of solar water heating system

Enhancing the Melting Process of Shell-and-Tube PCM Thermal Energy Storage Unit Using Modified Tube Design

Investigations on an evacuated tube solar water heater using hybrid-nano based organic phase change material

Enhancement of solar evacuated tube unit filled with nanofluid implementing three lobed storage unit equipped with fins

Comparative analysis on melting performance of PCM using rectangular and branching fin configurations in a shell and tube type thermal energy storing unit

Performance Optimization of Thermal Energy Storage Based Solar Collector

Numerical Analysis of Phase Change and Container Materials for Thermal Energy Storage in the Storage Tank of Solar Water Heating System

An experimental investigation of cylindrical shaped thermal storage unit consisting of phase change material based helical coil heat exchanger