Abstract:To heighten the oxidation inhibition capacity of HfB2-SiC coating, film-forming regulation of the self-formed compound layer was utilized to enhance the dynamic stability and the oxygen hindering capacity of the coating. The oxidation process of the HfB2-SiC coating in air from room temperature to 1700 °C can be divided into the lower temperature oxidation zone, the medium temperature protection zone and the high temperature corrosion zone. The oxidation activity of the coatings was significantly weakened in the medium temperature oxidation protection zone from 1100 °C to 1400 °C, which was selected as the film-forming regulation temperature region to ensure the lower film-forming wastage of the coatings. When the film-forming temperature was 1200 °C, the coating was uniformly covered by the glass layer with fewer defects. The values of active factor and inerting factor of the HfB2-SiC coating after film-forming at 1200 °C were 0.151 and 0.953 × 10−6 g cm−2 s−1, respectively, which show the lowest film-forming wastage of the coating. With further ascending the film-forming temperature, a large number of pores and cracks generated on the glass layer owing to the evaporation and release of the gaseous byproducts, which destroyed the structure of the glass layer and aggravated the oxidation wastage of the coating. With increasing the film-forming time at 1200 °C for 360 min, the protection efficiency of the HfB2-SiC coating increased to 99.13%, the oxygen permeability and carbon loss rate decreased by 79.6% and 67.8%, respectively, which slowed down the oxidation activity and improved the dynamic stability of the coating during oxidation.

Oxidation inhibition behaviors of the HfB2-SiC-TaSi2 coating for carbon structural materials at 1700 °C

Oxidation inhibition behaviors of HfB 2 ‐MoSi 2 ‐SiC oxygen blocking coating prepared by spark plasma sintering

Effect of film-forming regulation of the self-formed compound layer on the oxidation inhibition capacity of HfB2-SiC coating

Oxidation of TaB2-SiC coatings prepared by spark plasma sintering and effect of pre-oxidation treatments

Microstructure and oxidation behavior of SiOC coatings on C/C composites co-deposited with HMDS and TEOS by using CVD process

Preparation of MoSi2-modified HfB2-SiC ultra high temperature ceramic anti-oxidation coatings by liquid phase sintering

Oxygen blocking enhancement of HfB2-SiC coating using HfB2-HfSi2 alloyed composite powders by self-propagating high-temperature synthesis

Enhanced oxidation resistance of HfB2‐SiC‐ZrSi2 coating at 1700°C through low‐loss film‐forming treatment

Oxygen barrier resistance of HfB2-MoSi2-TaB2 coatings in a wide temperature region

Experimental and first-principles simulation study on oxidation behavior at 1700 °C of Lu2O3–SiC-HfB2 ternary coating for SiC coated carbon/carbon composites

An oxidation protective coating prepared by SiC densifying HfB2-SiC skeleton for SiC-coated C/C composites at 1473, 1773, and 1973 K

Oxygen barrier capability of ZrB2-SiC coating at 1700 °C strengthened by film-forming treatment

Influence of MoSi2 on oxidation protective ability of TaB2-SiC coating in oxygen-containing environments within a broad temperature range

Investigation on the oxidation and ablation behaviors of HfB2-SiC-Si/SiC-Si coatings for carbon/carbon composites

Enhancing oxygen‐blocking properties of HfB2‐MoSi2‐SiC coating by CeO2 modification

Effect of the ZrB2 content on the oxygen blocking ability of ZrB2-SiC coating at 1973K

Solid‐Solution Effects on the High‐Temperature Oxidation Behavior of Polymer‐Derived (Hf,Ta)C/SiC and (Hf,Ti)C/SiC Ceramic Nanocomposites

Oxidation ablation resistance of ZrB2-HfB2-SiC-TaSi2 coating prepared on C/C composite surface

TaSi2 modified HfB2‐SiC coating: preparation and ablation behavior

Nanosized Hf6Ta2O17 particles reinforced HfC ceramic coating for high temperature applications

High temperature oxidation behavior and mechanism of SiC-TaB2 composites