Design and Development of Sensing Unit for Wire Rope Tester
Sukesha Sharma Manu Sharma Nitika Garg Akshpreet Kaur Gaurav Sapra Naveen Aggarwal J. K. Goswami UIET,Panjab University,Chandigarh,IndiaSukesha Sharma received the BE and ME degrees in electronics and communication engineering and the PhD degree in 2016. She is currently an assistant professor with the department of IT,UIET,Panjab University,Chandigarh,India.Akshpreet Kaur is currently pursuing PhD from UIET,PU,Chandigarh. She has done ME from the electrical engineering department of UIET,Panjab University,Chandigarh. Email: itika Garg has done BE (ECE) from UIET Panjab University Chandigarh. Email: nitikagarg5665@gmail.comManu Sharma received a Btech degree in mechanical engineering from NIT Hamirpur and an Mtech and a PhD degree in active vibration control from IIT Delhi. He is currently a professor with the department of mechanical engineering,UIET,Panjab University Chandigarh. Email: manu@pu.ac.inGaurav Sapra is currently an assistant professor with the department of electrical and electronics engineering,UIET,Panjab University at Chandigarh. Email: gaurav.sapra@pu.ac.inNaveen Aggarwal is working as a professor at UIET,Panjab University and has more than 18 years of teaching experience. He did his PhD in year 2011 and Mtech in computer science & engineering from IIT,Kharagpur. Email: navagg@gmail.comJ K Goswami is working as a professor in the applied sciences department at UIET,Panjab University,Chandigarh. He has done his MSc and PhD in physics from Panjab University Chandigarh. Email: Goswami@pu.ac.in
DOI: https://doi.org/10.1080/03772063.2024.2409716
IF: 1.8768
2024-10-10
IETE Journal of Research
Abstract:In this work, a sensing unit on a Printed Circuit Board (PCB) has been designed to house hall sensors. Hall sensors are used to capture leakage flux signals from magnetized wire ropes for Non-Destructive Testing (NDT) of wire ropes. Various parameters are optimized before designing PCB, such as: Lift-off, orientation of sensor, number of hall sensors. Hall sensor signals are captured using DAQ card of NI® and program is written in LABVIEW® software. System is designed for: reducing noise in acquired signal (using RC filter), decreasing the number of channels for data acquisition system, reducing system cost and maintain signal fidelity.
telecommunications,engineering, electrical & electronic