Abstract:Utilising cooling stimulation as a thermal excitation means has demonstrated profound capabilities of detecting sub-surface metal loss using thermography. Previously, a prototype mechanism was introduced which accommodates a thermal camera and cooling source and operates in a reciprocating motion scanning the test piece while cold stimulation is in operation. Immediately after that, the camera registers the thermal evolution. However, thermal reflections, non-uniform stimulation and lateral heat diffusions will remain as undesirable phenomena preventing the effective observation of sub-surface defects. This becomes more challenging when there is no prior knowledge of the non-defective area in order to effectively distinguish between defective and non-defective areas. In this work, the previously automated acquisition and processing pipeline is re-designed and optimised for two purposes: 1-Through the previous work, the mentioned pipeline was used to analyse a specific area of the test piece surface in order to reconstruct the reference area and identify defects. In order to expand the application of this device over the entire test area, regardless of its extension, the pipeline is improved in which the final surface image is reconstructed by taking into account multiple segments of the test surface. The previously introduced pre-processing method of Dynamic Reference Reconstruction (DRR) is enhanced by using a more rigorous thresholding procedure. Principal Component Analysis (PCA) is then used in order for feature (DRR images) reduction. 2-The results of PCA on multiple segment images of the test surface revealed different ranges of intensities across each segment image. This potentially could cause mistaken interpretation of the defective and non-defective areas. An automated segmentation method based on Gaussian Mixture Model (GMM) is used to assist the expert user in more effective detection of the defective areas when the non-defective areas are uniformly characterised as background. The final results of GMM have shown not only the capability of accurately detecting subsurface metal loss as low as 37.5% but also the successful detection of defects that were either unidentifiable or invisible in either the original thermal images or their PCA transformed results.

Transient Channel Sagging Measurements Under Severe Thermal Loading Condition: An Optical Imaging Approach

NON-CONTACT MEASUREMENT TECHNIQUE FOR DYNAMIC RADIAL DEFORMATION OF EXPLOSION CONTAINMENT VESSELS

Color crosstalk correction for synchronous measurement of full-field temperature and deformation

High-frequency flashing of light source for synchronous measurement of temperature and deformation at elevated temperature

Image-Based Structural Dynamic Displacement Measurement Using Different Multi-Object Tracking Algorithms

High-temperature strain measurement using active imaging digital image correlation and infrared radiation heating

Removal of Optical Crosstalk Caused by Light Source for Synchronous Measurement of Temperature and Deformation

Synchronous in-situ measurement for deformation and temperature fields with high spatial and temporal resolution under dynamic loading

Full-field Measurement of Topography and Curvature by Coherent Gradient Sensing Method at High Temperature

Real-Time Temperature Monitoring under Thermal Cycling Loading with Optical Fiber Sensor

Traceable thermal imaging in harsh environments

Temperature and Deformation Measurement for Large-Scale Flat Specimens Based on Image Mosaic Algorithms.

Full-field Measurement of Surface Topographies and Thin Film Stresses at Elevated Temperatures by Digital Gradient Sensing Method

Overcoming High Luminance Gradient Using Serial Exposure Time Method for Synchronous Full-Field Measurement of Temperature and Deformation

Synchronous Measurement of Temperature and Deformation by an Ultraviolet Imaging System and Monochromatic Pyrometry at Extreme Temperatures

Application of Image Analysis Technique in Visualization of Failure During the Testing of Materials

Monitoring the thermal deformation of steel beams via vision metrology

Digital Gradient Sensing Method to Evaluate Thermal Stress at Elevated Temperatures

Research on Synchronous Measurement Technique of Temperature and Deformation Fields Using Multispectral Camera with Bilateral Telecentric Lens

An Automated Pipeline for Dynamic Detection of Sub-Surface Metal Loss Defects across Cold Thermography Images

Measurement of Transmission Lines Conductor Sag Using Image Processing