Abstract:Superconducting nanowire single photon detectors (SNSPDs) promise to combine near-unity quantum efficiency with >100 megacounts per second rates, picosecond timing jitter, and sensitivity ranging from x-ray to mid-infrared wavelengths. However, this promise is not yet fulfilled, as superior performance in all metrics is yet to be combined into one device. The highest single-pixel detection efficiency and the widest bias windows for saturated quantum efficiency have been achieved in SNSPDs based on amorphous materials, while the lowest timing jitter and highest counting rates were demonstrated in devices made from polycrystalline materials. Broadly speaking, the amorphous superconductors that have been used to make SNSPDs have higher resistivities and lower critical temperature (Tc) values than typical polycrystalline materials. Here, we demonstrate a method of preparing niobium nitride (NbN) that has lower-than-typical superconducting transition temperature and higher-than-typical resistivity. As we will show, NbN deposited onto unheated SiO2 has a low Tc and high resistivity but is too rough for fabricating unconstricted nanowires, and Tc is too low to yield SNSPDs that can operate well at liquid helium temperatures. By adding a 50 W RF bias to the substrate holder during sputtering, the Tc of the unheated NbN films was increased by up to 73%, and the roughness was substantially reduced. After optimizing the deposition for nitrogen flow rates, we obtained 5 nm thick NbN films with a Tc of 7.8 K and a resistivity of 253 μΩ cm. We used this bias sputtered room temperature NbN to fabricate SNSPDs. Measurements were performed at 2.5 K using 1550 nm light. Photon count rates appeared to saturate at bias currents approaching the critical current, indicating that the device's quantum efficiency was approaching unity. We measured a single-ended timing jitter of 38 ps. The optical coupling to these devices was not optimized; however, integration with front-side optical structures to improve absorption should be straightforward. This material preparation was further used to fabricate nanocryotrons and a large-area imager device, reported elsewhere. The simplicity of the preparation and promising device performance should enable future high-performance devices.

A 16-pixel NbN nanowire single photon detector coupled with 300 micrometer fiber

Sixteen-Pixel NbN Nanowire Single Photon Detector Coupled with 300-Μm Fiber

Microfiber-coupled superconducting nanowire single-photon detector for near-infrared wavelengths.

Microfiber Coupled Superconducting Nanowire Single-Photon Detectors

Ultra-broadband Microfiber-Coupled Superconducting Single-Photon Detector

NbN Superconducting Nanowire Single-Photon Detector Fabricated on MgF2substrate

NbN Superconducting Nanowire Single-Photon Detector with an Active Area of 300 Μm-in-diameter

NbN Superconducting Nanowire Single-Photon Detector With 90.5% Saturated System Detection Efficiency and 14.7 ps System Jitter at 1550 nm Wavelength

Large-sensitive-area Superconducting Nanowire Single-Photon Detector at 850 Nm with High Detection Efficiency

A 16-channel fiber array-coupled superconducting single-photon detector array with average system detection efficiency over 60% at telecom wavelength

64-pixel NbTiN superconducting nanowire single-photon detector array for spatially resolved photon detection

High Efficiency, Large-Active-area Superconducting Nanowire Single-Photon Detectors

Superconducting Nanowire Single Photon Detector with Efficiency over 60% for 2-Μm-wavelength

A Superconducting Nanowire Single Photon Detector on Lithium Niobate

Superconducting Nanowire Single-Photon Detector with A System Detection Efficiency over 80% at 940-Nm Wavelength

Single Photon Detectors Based on Superconducting Nanowires over Large Active Areas

High Efficiency Superconducting Nanowire Single Photon Detector at Wavelength 940 Nm

Mid-infrared Nb4N3-based Superconducting Nanowire Single Photon Detectors for Wavelengths Up to 10 Μm.

Bias Sputtered Nbn and Superconducting Nanowire Devices

Multimode Fiber Coupled Superconductor Nanowire Single-Photon Detector

Supercontinuum Single-Photon Detector Using Multilayer Superconducting Nanowires