Abstract:In this paper, the dynamic behavior of a rotor system with electromechanically coupled boundary condition under periodic axial load is studied, where the boundary condition is derived from a ring-shaped piezoelectric damper which is developed for vibration control of rotor system. This damper is based on the piezoelectric shunt damping technique, which can produce much or little damping performance depends on the selection of shunt circuit parameters. By using assumed mode method and Lagrange equation, the equations of motion are derived. Actually these equations can also be derived from a general forced parametrically excited gyroscopic system. Thus, to analyze such system, a method of multiple scales is developed firstly, where a general procedure is proposed to establish solvability conditions. Subsequently, this procedure is applied to obtain the analytical instability boundaries and forced vibration responses. The analytical results show that the additional combination instability regions are created due to the introduction of shunt circuit. When the parametrically excited eccentric rotor is rotating, the parametric vibrations are superimposed on the unbalanced responses. As the resistance value of shunt circuit is increasing, both parametric vibrations and unbalance vibrations can be significantly suppressed. For the unbalanced responses, both the resonance and anti-resonance phenomena can be observed; whereas for the parametric vibrations, only the resonance phenomena exist. These phenomena indicate that we may achieve great vibration control performance for the rotor parametric vibrations by introducing the piezoelectric shunt damping, as long as the circuit parameters are well adjusted. To validate the obtained analytical expressions, the numerical methods are applied. Specifically, the discrete state transition matrix method (DSTM) is applied to validate the analytical instability boundaries and the Runge-Kutta method is conducted to verify the analytical frequency response functions.

Dynamic modeling and parametric instability analysis of internally damped rotating composite shafts in inertial and rotating frames

Modeling a Two-Span Rotor System Based on the Hamilton Principle and Rotor Dynamic Behavior Analysis

Modal Frequency and Stability of Rotor System Supported by Viscoelastic Elastomeric Dampers

Parametric Study of Damping Characteristics of Rotating Laminated Composite Cylindrical Shells Using Haar Wavelets

Parametric Instability of a Jeffcott Rotor with Rotationally Asymmetric Inertia and Transverse Crack

Instability Region Classification and Control of Periodically Axially Loaded Rotor

Dynamic Modeling of Helicopter Rotor Blades

Rotor Aeroelastic Stability Modeling Based on Inertial Coordinate Frame

Parametric Instability Of Two-Disk Rotor With Two Inertia Asymmetries

Stability analysis of a rotor system with electromechanically coupled boundary conditions under periodic axial load

Underestimated dynamic instability regions of framed structures with multiple systems induced by autoparametric resonance

Theoretical analysis of a parametrically excited rotor system with electromechanically coupled boundary condition

Variable angle tow-steered fibres based rotating composite beam with rotary oscillations – Parametric excitation/instability analysis

Aeroelastic analysis and structural parametric design of composite rotor blade

Nonlinear forced vibration analysis of the composite shaft-disk system combined the reduced-order model with the IHB method

Nonparametric Modeling and Vibration Analysis of Uncertain Jeffcott Rotor with Disc Offset

Dynamic characteristics analysis of a dual-rotor system with inter-shaft bearing

Stability analysis of high speed milling process considering internal damping of composite cutter bar and gyroscopic effect in rotating coordinates

A Comprehensive Dynamic Model to Investigate the Stability Problems of the Rotor–bearing System Due to Multiple Excitations

Structural Design and Dynamic Analysis of Carbon Fiber Reinforced Plastic Shaft with Metal Parts

Parametric Instability of Flexible Rotor-Bearing System under Time-Periodic Base Angular Motions