Abstract:Ceramic vat photopolymerization has been one of the promising three-dimensional printing technologies for personalized zirconia crown with high dimensional accuracy and surface topography. However, insufficient material stability and complex procedure about auxiliary supports limit the application based on low viscosity slurry. In this work, we developed a photocurable ceramic paste, in which the high static viscosity and high yield stress characteristics allowed it to exhibit sufficient anti-settling and self-supporting capabilities. The rheological characteristics of the as prepared paste were measured by stress-controlled rheometer, and conformal contactless support was designed including top conformal structure without contact with the crown and appropriate empty layer. The 3D precision of crown was evaluated by laser scanning confocal microscope and optical surface scanner. In addition, mechanical properties and biocompatibility of sintered samples were systematically evaluated. The results demonstrated that the yield stress of the ceramic paste approached around 600 Pa, and integrate morphology at the bottom of the crown with the contactless supported zone was observed. 3D deviation between the printed crown scan data and the reference model was reduced within the range of 40–70 μm. Finally, the flexural strength and fracture toughness of the sintered zirconia ceramics reached 1117 MPa and 7.76 MPa⋅m 1/2 , respectively, as well as good biocompatibility by the lack of cytotoxicity and hemolytic reaction. The results indicate an important practical significance for the development of vat photopolymerization printing technology of viscoelastic paste and conformal contactless support strategy to realize the integrated manufacturing of ceramic crowns.

Development of a highly loaded zirconium carbide paste for material extrusion additive manufacturing

Additive manufacturing of dense zirconia ceramics by fused deposition modeling via screw extrusion

Rheological characterization of pastes of alumina-toughened zirconia with additions of carbon nanofibers and evaluation of their printability via material extrusion

Paste extrusion‐based 3D printing of fiber‐reinforced ultra high‐temperature ceramics

Fabrication of High-Performance Al2O3-ZrO2 Composite by a Novel Approach That Integrates Stereolithography-Based 3D Printing and Liquid Precursor Infiltration

UV-Curing Assisted Direct Ink Writing of Dense, Crack-Free, and High-Performance Zirconia-Based Composites With Aligned Alumina Platelets

Innovative ceramic paste for stereolithography additive manufacturing alumina core applied in turbine blade casting

Material extrusion printing of WC-8%Co cemented carbide based on partly water-soluble binder and post-processing

Optimization of Ceramic Paste Composition for 3D Printing via Robocasting

Material extrusion for ceramic additive manufacturing with polymer-free ceramic precursor binder

Preparation of high solid loading and low viscosity ceramic slurries for photopolymerization-based 3D printing

Additive manufacturing of fiber reinforced zirconia‐toughened alumina (ZTA) ceramic matrix composites (CMC) by material extrusion‐based technology

Material extrusion additive manufacturing of zirconia: from filament characterisation to Weibull statistics

Pressureless sintering and properties of additively manufactured ZrB2–SiC

Additive Manufacturing of Zirconia-Based Pastes for Dental Prosthesis Via Robocasting Method

Rheological behavior and curing deformation of paste containing 85 wt% Al2O3 ceramic during SLA-3D printing

High-performance integrated manufacturing of a 3Y-TZP ceramic crown through viscoelastic paste-based vat photopolymerization with a conformal contactless support

Injection molding of surface modified powders with high solid loadings: A case for fabrication of translucent alumina ceramics

Preparation and stereolithography 3D printing of ultralight and ultrastrong ZrOC porous ceramics

Fabrication of complicated ceramic parts by gelcasting based on additive manufactured acetone-soluble plastic mold

A Strategy to Obtain a High-Density and High-Strength Zirconia Ceramic Via Ceramic Injection Molding by the Modification of Oleic Acid