Abstract:The nonuniformity of stress and strain analysis is an important consideration that describes the bond behavior between concrete and externally bonded fiber reinforced polymer (FRP) laminates. The interfacial stress transfer between FRP and concrete generates a longitudinal strain gradient in the longitudinal (or FRP fiber) direction. Most of the available studies in this area have focused on nonuniformity in the longitudinal direction. In this paper, the nonuniformity in the FRP width direction is investigated by studying the strain distribution using digital image correlation (DIC) full-field optical techniques. In the direction along the FRP width, there is an area in the middle that has consistent strain and stress, while the edge regions have strain and stress gradients. During the complete debonding process, the width of the central area is found to be insignificantly affected by the concrete strength but significantly affected by the FRP stiffness. The fracture characteristics below the central region are purely Mode II fracture. However, the complex curved cracks and high in-plane shear strains at the interface near the FRP edge regions show a mixed mode with Modes II and III. This boundary effect results in a significant difference in the bond–slip characteristics of FRP along the width direction. The maximum bond stress of the central region is higher than that of the edge region. However, for FRP with higher stiffness, the inhomogeneity of the stress distribution is weakened. Moreover, it is reasonable to find that calculating the sum of the bearing capacity of the single FRP strips along the width direction is close to the experimental bond strength. Based on the research findings in this study, it is qualitatively recommended that the width factor model in calculating FRP-concrete bond strength should include the significant effect of FRP stiffness.

Width Effect in FRP–Concrete Debonding Mechanism: A New Formula

Ultimate Strength of Reinforced Concrete Beams Retrofitted with Hybrid Bonded Fiber-Reinforced Polymer

Experimental Study on Dynamic Behavior of GFRP-to-concrete Interface

Effect of Shear Resistance on Flexural Debonding Load-Carrying Capacity of RC Beams Strengthened with Externally Bonded FRP Composites

Experimental study on dynamic behavior of CFRP-to-steel interface

Nonuniformity in stress transfer across FRP width of FRP-concrete interface

Fracturing behaviors of FRP-strengthened concrete structures

Effect of sustaining load level on flexural behavior of RC beams retrofitted with CFRP sheets

Experimental Investigation of Fatigue Debonding Growth in FRP–Concrete Interface

Size Effects for Reinforced Concrete Beams Strengthened in Shear with CFRP Strips

Strengthening of concrete beams using fiber-reinforced platics

Experimental and 3D Numerical Study on CFRP–Concrete Interface Under Dynamic Loading

Debonding mechanism of FRP strengthened flat surfaces: Analytical approach and closed form solution

A Moving Interface Finite Element Formulation to Predict Dynamic Edge Debonding in FRP-Strengthened Concrete Beams in Service Conditions

Effects of concrete heterogeneity on FRP-concrete bond behaviour: Experimental and mesoscale numerical studies

The effect of beam depth on the shear behavior of reinforced concrete beams externally strengthened with carbon fiber–reinforced polymer composites

Finite element analyses of failure of fiber reinforced polymer-concrete interface considering the concrete tension–compression softening effect

Effective Width of Steel–concrete Composite Beam at Ultimate Strength State

Insight into the Shear Failure Mechanism of Wound FRP Reinforced Concrete Beams Through Numerical Simulations Considering Interface Damage and Material Anisotropy

Effects of the Concrete Strength and FRP Reinforcement Type on the Non-Linear Behavior of Concrete Deep Beams

Investigation of Bond in Concrete Structures Strengthened with Near Surface Mounted Carbon Fiber Reinforced Polymer Strips