Abstract:The geometric complexity and high-pressure gradients that characterize the design of the flow field of gear pumps make it very difficult to obtain an accurate CFD simulation of the component. Usually, assumptions are made both in terms of geometrical features and physics being included in the analysis. The contact between the teeth, which is a key factor for the correct functioning of these pumps, represents a critical challenge in 3D CFD simulations, mainly due to the intrinsic limits of the dynamic meshing techniques that can hardly effectively manage a zero or close to zero gap point forming during gear rotation. The geometric complexity and high-pressure gradients that characterize the gear pump flow field make a CFD analysis quite difficult, and the contact between the gear teeth is usually avoided, thus being an extremely important feature. In this paper, a gear pump composed of inlet and outlet pipes was considered, and the contact between the gear’s teeth was modeled in two different ways, one where it is effectively implemented and one where it is avoided using distancing and a proper casing modification. Herein, a new methodology is proposed for the application of the dynamic mesh method in the Simcenter STAR-CCM+ environment using an adaptive remeshing technique. The proposed methodology is compared with the alternative overset meshing method available in the software. The new meshing method is implemented using a user-routing that reproduces the real geometry of the gears while rotating during the pump operation, with teeth contact included. The routine is optimized in order to limit the additional computation and time needed for the remeshing process. The results that can be obtained using the two meshing approaches for the gear pump are compared in terms of computational effort and the accuracy of the results. The two methods showed opposite results in almost all the reported results, with the overset being more precise in the radial pressure evaluation and the dynamic being more reliable in the cavitation/aeration extension cloud.

Application analysis and research of cylindrical roller bearing in external gear high pressure pump

Experimental Research on Performance of Water Hydraulic Internal Gear Pump

Multi-objective Optimization Design of Sliding Bearing of High-speed Centrifugal Pump Based on Lubrication Characteristics Analysis

Study on Dynamic Pressure Effect of Gas Bearings in Fuel Cell Vehicles

Experimental and Numerical Analysis of a Self-Circulating Oil Bearing System for Gear Pumps

Experimental and Numerical Study of the Influence of Loading Direction on the Lubrication and Cooling of Self-Circulating Oil Bearing System Applied in Internal Gear Pumps

Numerical and experimental studies on flow performances and hydraulic radial forces of an internal gear pump with a high pressure

Numerical Simulation and Experimental Research on Passive Hydrodynamic Bearing in a Blood Pump

Investigation on the Radial Micro-Motion about Piston of Axial Piston Pump

Study of the Cavitation Phenomenon Inside Roller Vane Pump

The design and analysis of a high-speed circular arc gear pump journal bearing

Numerical Simulation and Analysis on Hydraulic Performance in Vertical Canned Motor Pump

Finite Element Analysis of Reciprocating Sealing Component of Radial Single-piston Pump

Design and Performance Analysis of a Circular-Arc Gear Pump Operating at High Pressure and High Speed

Research on Wear Prediction of Piston/cylinder Pair in Axial Piston Pumps

A Thermohydrodynamic Analysis of the Self-Lubricating Bearings Applied in Gear Pumps Using Computational Fluid Dynamics Method

Analysis of axial force of double circular arc helical gear hydraulic pump and design of its balancing device

An advanced pressure pulsation model for external gear pump

Development of a Numerical Approach for the CFD Simulation of a Gear Pump under Actual Operating Conditions

Experimental and Numerical Studies on Erosion Damage in Damping Holes on the Valve Plate of an Axial Piston Pump