Abstract:Single-photon detectors based on the superconducting transition-edge sensor (TES) are used in a number of visible to near-infrared (VNIR) applications, particularly for photon-number-resolving measurements in quantum information science. To be practical for large-scale photonic quantum computing or for future spectroscopic imaging applications in astronomy, the size of VNIR TES arrays must be increased from a few pixels to many thousands. Historically, TES arrays have been read out with multiplexed superconducting quantum interference devices (SQUIDs), but the microsecond-duration pulse signals of VNIR TESs are notoriously difficult to multiplex. In this manuscript, we introduce the kinetic inductance current sensor (KICS), a more readily scalable readout technology that exploits the nonlinear kinetic inductance in a superconducting resonator to make sensitive current measurements. KICS devices can replace SQUIDs for many applications because of their ability to measure fast, high slew-rate signals, their compatibility with standard microwave frequency-division multiplexing techniques, and their relatively simple fabrication. Here, we demonstrate the readout of a VNIR TES using a KICS with $3.7$ $\text{MHz}$ of bandwidth. We measure a readout noise of $1.4$ $\text{pA}/\sqrt{\text{Hz}}$, considerably below the TES noise at frequencies of interest, and a TES energy resolution of $(0.137 \pm 0.001)$ $\text{eV}$ at $0.8$ $\text{eV}$, comparable to resolutions observed with non-multiplexed SQUID readouts.

Demonstration of Simultaneous Optical Transition-Edge Sensors Readout Using Microwave SQUID Multiplexer with 5 MHz Flux Ramp Modulation

A Spread-Spectrum SQUID Multiplexer

Simultaneous readout of 128 X-ray and gamma-ray transition-edge microcalorimeters using microwave SQUID multiplexing

Low-noise microwave SQUID multiplexed readout of 38 x-ray transition-edge sensor microcalorimeters

Recent Advances in Frequency-Multiplexed TES Readout: Vastly Reduced Parasitics and an Increase in Multiplexing Factor with sub-Kelvin SQUIDs

Kinetic inductance current sensor for visible to near-infrared wavelength transition-edge sensor readout

Simultaneous Monitoring of Multichannel Terahertz Communication Signals Based on a Photoconductive Sampling

An Impedance-Modulated Code-Division Microwave SQUID Multiplexer

Multiplexing Technology Based on SQUID for Readout of Superconducting Transition-Edge Sensor Arrays

Frequency domain multiplexing readout for large arrays of transition-edge sensors

Crosstalk Effects in Microwave SQUID Multiplexed TES Bolometer Readout

Advanced code-division multiplexers for superconducting detector arrays

An optical transition-edge sensor with high energy resolution

Improved microwave SQUID multiplexer readout using a kinetic-inductance traveling-wave parametric amplifier

Developments on frequency domain multiplexing readout for large arrays of transition-edge sensor X-ray micro-calorimeters

Frequency division multiplexing readout of a transition edge sensor bolometer array with microstrip-type electrical bias lines

Frequency Multiplexed SQUID Readout of Large Bolometer Arrays for Cosmic Microwave Background Measurements

Frequency shift algorithm: Design of a baseband phase locked loop for frequency-domain multiplexing readout of x-ray transition-edge sensor microcalorimeters

Flux ramp modulation based hybrid microwave SQUID multiplexer