Abstract:Field test results show that about 15% to 40% of building heat loss in China is attributable to poor heating systems regulation. The current method for addressing this problem is to install thermostatic radiator valves (TRVs) to the ends of radiators, a method adapted from northern Europe. However, this method has resulted in poor performance from delayed controlling action due to thermal inertia as well as insufficient system control accuracy. This is further compounded by incorrect operation by system users and a lack of financial incentives to regulate the system if users are not billed for their heat consumption. We present a new method for simultaneously heat controlling and metering. The core challenge is to design a control strategy that will maintain the room’s temperature. Thus, we established dynamic heat transfer models for water flow, the radiator and the building so as to obtain the optimal heating strategy. We also simulated the indoor thermal dynamic performance of the heating system with different heating loads, supply water temperatures, and supply water flow rates using three methods: a continuously changing flow rate (Method 1), a step-change flow rate based on temperature deviation (Method 2) and an intelligent step-change flow rate (Method 3) which predicts the duty cycle of the valve in the proceeding period and controls the valve’s on-time. The simulation results indicate the performance of these three methods. For Method 1, as the room temperature is above the set point, the flow rate can be automatically reduced to a level which is proportional to the room temperature deviation. Further, the scale factor of the flow rate is designed according to the +2°C deviation, so it is accepted that the room temperature is higher than the set point by +2°C using this method. However, this low control precision is unsatisfactory. The mean temperature is higher than the set point and greatly affected by the heating load and supply water’s temperature and flow rate. For Method 2, the controlling action is delayed by thermal inertia, the room temperature fluctuates between the highest and lowest levels, and the temperature deviation can be greater than the set value. For Method 3, both the simulation and field test results showed that room temperature deviation was maintained within a ±0.5°C range under the various conditions. This method appears relatively robust and adaptable, and was the best control strategy of the three methods.

Preheating time estimation in intermittent heating with hot-water radiators by considering model uncertainties

Preheating Quantification for Smart Hybrid Heat Pumps Considering Uncertainty

Nonlinear Dynamic Models with Uncertainties Measured by Fuzzy Sets for Radiator-Heated Buildings

A Multiple Model Approach for Predictive Control of Indoor Thermal Environment with High Resolution

Estimation of Time-Dependent Parameters of a Heat-Integrated Distillation Column System

Modeling and Measurement Study on an Intermittent Heating System of a Residence in Cambridgeshire

A simulation study on the heating characteristics of residential buildings using intermittent heating in Hot-Summer/Cold-Winter areas of China

Investigating the Effect of Solar Heat Gain on Intermittent Operation Characteristics of Radiant Cooling Floor

Analysis on Uncertainty Assessment Case of Radiator Thermal Performance Test

Parameter identification framework of thermal network model for ventilated heating floor

A Two-Dimensional Numerical Analysis for Thermal Performance of an Intermittently Operated Radiant Floor Heating System in a Transient External Climatic Condition

A model to compare convective and radiant heating systems for intermittent space heating

Evaluation Methods of Intermittent Heating at the Individual Scale: from Theory to Terminal Application

A novel on-off TRV adjustment model and simulation of its thermal dynamic performance

Parametric study on the effect of radiant heating system on indoor thermal comfort with/without external thermal disturbance

Dynamic simulation of space heating systems with radiators controlled by TRVs in buildings

Indoor Thermal Environment Improvement Based on Switchable Radiation/Convection-Combined Intermittent Heating: Comparison Between Conventional Terminals and Integrated Novel Terminal

Low-order gray-box modeling of heating buildings and the progressive dimension reduction identification of uncertain model parameters

Dynamic Process Simulation of Indoor Temperature Distribution in Radiant-Convective Heating Terminals

Simulation on Hydraulic Heating System of Building under the Control of Thermostat Radiator Valves

The Intermittent Operation Control Strategy of Low-Temperature Hot-Water Floor Radiant Heating System