Abstract:Noise from rail transit viaducts often has a negative effect on surrounding buildings and nearby residents. To reduce the bridge vibration and radiated noise, floating slab tracks have been widely adopted in rail transit viaducts. To calculate the vibration of coupled track-bridge systems, both time-domain and frequency-domain methods can be applied although their relative performance is not very clear. This study aims to compare the two approaches and then provide some guidelines in choosing the appropriate method for predicting the vibration. The principle and methodology of the two calculation methods are firstly introduced, and the models for the train, floating slab track and bridge are developed using similar parameters. To further improve the efficiency and accuracy of the frequency-domain method, a half period method and a weighted average method are proposed to calculate the average responses of a certain point on the rail, floating slab and bridge to approximate the response during the pass-by. An indirect method is used to estimate the wheel–rail combined roughness from the measured rail acceleration when the train is running on the bridge, and compared with the direct measurement rail roughness. For the vibration of the bridge and floating slab, comparisons are made between results obtained from the time-domain and frequency-domain methods with different train speeds, and between results from experiment and simulation with different roughness. It is found that the wheel–rail contact forces and other structural responses from the two approaches show good consistency in the frequency region above 20 Hz. It is shown that a good approximation of the response during the pass-by can be obtained using the frequency-domain method by adopting the half period average or a simplified weighted average of two wheel position cases. When using the measured roughness and estimated roughness, the simulated vibration of the floating slab and bridge match well with the experimental results, and the indirect method can be used to modify direct measurement roughness in lower frequency regions. In the vibration prediction, the rail vibration or roughness, and other parameters in the vehicle–track–bridge system, should be measured accurately to ensure high reliability.

Theoretical study on a dual-beam model for detection of track/bridge frequencies and track modulus by a moving vehicle

Three-dimensional Finite Element Simulation on Moving Load Induced Track Response over Stiffness-varied Base

Simultaneous identification of the frequencies and track irregularities of high-speed railway bridges from vehicle vibration data

Study of Ground Vibration from Trains Caused by Track Irregularities

Effect of Track Spectrum on the Dynamic Responses of Passenger–Train–Bridge System

Novel recursive formula for removing damping distortion effect on bridge mode shape restoration using a two-axle scanning vehicle

Experimental study on vertical vehicle-rail-bridge coupling of medium and low speed maglev train based on track beam with different stiffness

A New Track Model for Vertical Vibration Analysis of Vehicle-Ballastless Track-Bridge Coupling

Vehicle-tunnel coupled vibration responses of a submerged floating tunnel under excitation of track irregularities

Effect of damping on torsional-flexural frequencies of monosymmetric thin-walled beams scanned by moving vehicles

Furthering extraction of torsional–flexural frequencies for thin-wall beams from the rocking motion of a two-wheel test vehicle

Quantitative Detection of Vertical Track Irregularities under Non-Stationary Conditions with Variable Vehicle Speed

Frequency-domain method for non-stationary stochastic vibrations of train-bridge coupled system with time-varying characteristics

Analysis of Train-Track-Bridge Coupling Vibration Characteristics for Heavy-Haul Railway Based on Virtual Work Principle

A model-based approach for joint estimation of track irregularities and track support modulus from trackside measurements in railway turnouts

Subspace Identification of Bridge Frequencies Based on the Dimensionless Response of a Two-Axle Vehicle

Scanning torsional-flexural frequencies of thin-walled box girders with rough surface from vehicles’ residual contact response: Theoretical study

Frequency Identification of Equal-Span Continuous Girder Bridge Based on Moving Vehicle Responses

Comparison of time-domain and frequency-domain models for vibration prediction of a rail transit viaduct paved with floating slab track

Dynamic Response of Axle-boxes to Rail Unevenness Excitation due to Multiple Wheel-rail Interactions and Its Measurability Analysis

Ride comfort of high-speed trains travelling over railway bridges