Abstract:The Journal of Strain Analysis for Engineering Design, Ahead of Print. In scientific studies, sheet metal is usually considered as a two-dimensional body. Thus, it is accepted that material properties are in most cases regarded homogeneous in thickness direction. However, a gradation of certain properties becomes apparent when going beyond the standard characterization methods for sheet metals, which can for example, influence the springback behavior and the thinning of the sheet after forming. Thus, the aim of this work is to further improve the prediction accuracy of springback after forming in simulations, by implementing several inhomogeneous properties over the sheet thickness in an existing material model. For this purpose, the entire procedure from the identification of the inhomogeneous properties for describing the gradation to the implementation in a numerical model and its validation by comparing experimental and simulated bending operations is carried out on a DC04 cold-forming steel in order to prove its influence on the springback behavior. It is shown that including graded material properties in simulations does indeed have an impact on the prediction quality of springback and that the information about inhomogeneous properties can be provided by existing characterization methods with a high local resolution like electron backscatter diffraction or X-ray stress analysis. In a further step, it was possible to validate the improvement in numerical accuracy by comparing the prediction of the springback angle from both the existing and the extended model with experimental bending results. Both the initial model as well as the model supplemented with the 3D properties provide a good prediction accuracy in the solution heat treated material state. For the predeformed material, however, the initial numerical model predicts a springback angle of about 13°, which deviates remarkably from the experimentally obtained mean value of about 17°. The extended model delivers a significantly improved accuracy in springback prediction in relation to the initial prediction (deviation of 4°) with a minor deviation of only about 0.8°, which proves the importance of considering the gradation of material properties in thickness direction for an overall higher dimensional accuracy of sheet metal products.

Analysis of TRIP Steel HCT690 Deformation Behaviour for Prediction of the Deformation Process and Spring-Back of the Material via Numerical Simulation

Experimental and Numerical Thickness Analysis of TRIP Steel under Various Degrees of Deformation in Bulge Test

Study on Springback for TRIP-aided Steel Sheet

Numerical and Experimental Analysis of Stress-Strain Characteristics in DP 600 and TRIP 400/700 Steel Sheets

Improving the Accuracy of Stamping Analyses Including Springback Deformations

Prediction of Martensitic Transformation and Deformation Behavior in the TRIP Steel Sheet Forming

Numerical springback prediction for high-strength aluminum alloys based on the sheet metal upsetting test

Effect of complicated deformation behaviors during cold stamping on springback prediction of DP980 steel

Rheological Behavior of TRIP600 Steel during Deformation

Describing the Non-Saturating Cyclic Hardening Behavior with a Newly Developed Kinematic Hardening Model and Its Application in Springback Prediction of DP Sheet Metals

Characterisation and modelling of in-plane springback in a commercially pure titanium (CP-Ti)

Investigation on the effect of friction and material behavior models on the springback simulation precision: application to automotive part B-Pillar and material TRIP800 steel

Adaptive multiple scale meshless simulation on springback analysis in sheet metal forming

A Constitutive Model Coupling with TRIP Effect and Applying to the Sheet Metal Forming for TRIP Multi-phase Steels

Influences of the Evolving Plastic Behavior of Sheet Metal on V-bending and Springback Analysis Considering Different Stress States

Modeling and FE Simulation of Quenchable High Strength Steels Sheet Metal Hot Forming Process

Analysis on the Effects of Numerical Simulation Precision on Springback Prediction

Comparison of Material Models for Spring Back Prediction in an Automotive Panel Using Finite Element Method

A Constitutive Model for Spring-Back Prediction in Which the Change of Young's Modulus with Plastic Deformation is Considered

Material Modeling of Hot-Rolled Steel Sheet Considering Differential Hardening and Hole Expansion Simulation

Improvement of process control in sheet metal forming by considering the gradual properties of the initial sheet metal