Abstract:In this study, we use discrete dislocation dynamics (DDD) simulation to investigate the effect of heterogeneous dislocation density on the transition between quasi-elastic deformation and plastic flow in face-centered cubic single crystals. By analyzing the stress-strain curves of samples with an initial, axial dislocation density gradient, we arrive at the following conclusions: (i) in the regime of quasi-elastic deformation before the onset of plastic flow, the effective elastic modulus of the simulated samples falls significantly below the value for a dislocation-free crystal. This modulus reduction increases with decreasing dislocation density gradient: crystals with homogeneous dislocation distribution are thus weakest in the quasi-elastic regime; (ii) the transition towards plastic flow occurs first in regions of reduced dislocation density. Therefore, the overall yield stress decreases with increasing dislocation density gradient; (iii) crystals with dislocation density gradient exhibit a more pronounced hardening stage during which stress is re-distributed onto stronger regions with higher dislocation density until the sample flows at a constant flow stress that is approximately independent on dislocation density gradient. We interpret these findings in terms of a continuum dislocation dynamics inspired model of dislocation density evolution that accounts for inversive dislocation motions. The transition between quasi-elastic and plastic deformation is interpreted as a transition from inversive to non-inversive dislocation motion, and the initial differences in elastic modulus are related to a density dependent polarizability of the dislocation system. The subsequent plastic flow behavior is analyzed in terms of a modified version of Mughrabi's composite model.

Multigap diffraction at CDF

Spatial fluctuations in transient creep deformation

Power-Law Creep from Discrete Dislocation Dynamics

Dislocations Jam At Any Density

Dislocation dynamics modelling of the creep behaviour of particle-strengthened materials

Creep dynamics of athermal amorphous materials: a mesoscopic approach

An Atomistic Study of Diffusion-Mediated Plasticity and Creep using Phase Field Crystal Methods

Submicron plasticity: yield stress, dislocation avalanches, and velocity distribution

A Discrete Dislocation Plasticity Model of Creep in Polycrystalline Thin Films

Creep and flow of glasses: strain response linked to the spatial distribution of dynamical heterogeneities

Creep motion of elastic interfaces driven in a disordered landscape

Atomistic and Continuum Studies of Diffusional Creep and Associated Dislocation Mechanisms in Thin Films on Substrates

Unravelling the jerky glide of dislocations in body-centred cubic crystals

Enhanced mobility of dislocation network nodes and its effect on dislocation multiplication and strain hardening

Recoverable Creep Deformation and Transient Local Stress Concentration Due to Heterogeneous Grain-Boundary Diffusion and Sliding in Polycrystalline Solids

Dislocation dynamics and crystal plasticity in the phase field crystal model

On Newtonian Viscoplastic Dislocation Creep and the Effect of the Peierls Stress

Dislocation avalanches from strain-controlled loading: A discrete dislocation dynamics study

Long-range angular correlations of particle displacements at a plastic-to-elastic transition in jammed amorphous solids

Microplasticity and yielding in crystals with heterogeneous dislocation distribution

Depinning transition of dislocation assemblies: pileup and low-angle grain boundary