Stationary dislocation motion at stresses significantly below the Peierls stress: Example of shuffle screw and 60 ∘ dislocations in silicon
Hao Chen,Valery I. Levitas,Liming Xiong,Xiancheng Zhang
DOI: https://doi.org/10.1016/j.actamat.2021.116623
IF: 9.4
2021-03-01
Acta Materialia
Abstract:<p>The stationary motion of shuffle screw and <span class="math"><math>60∘</math></span> dislocations in silicon when the applied shear, <span class="math"><math>τap,</math></span> is much below the static Peierls stress,<span class="math"><math>τpmax,</math></span> is proved and quantified through a series of molecular dynamics (MD) simulations at 1 K and 300 K, and also by solving the continuum-level equation of motion, which uses the atomistic information as inputs. The concept of a dynamic Peierls stress, <span class="math"><math>τpd,</math></span> below which a stationary dislocation motion can never be possible, is built upon a firm atomistic foundation. In MD simulations at 1 K, the dynamic Peierls stress is found to be <span class="math"><math>0.33GPa</math></span> for a shuffle screw dislocation and <span class="math"><math>0.21GPa</math></span> for a shuffle <span class="math"><math>60∘</math></span> dislocation, versus <span class="math"><math>τpmax</math></span> of <span class="math"><math>1.71GPa</math></span> and <span class="math"><math>1.46GPa,</math></span> respectively. The critical initial velocity <span class="math"><math>v0c(τap)</math></span> above which a dislocation can maintain a stationary motion at <span class="math"><math>τpd<τap<τpmax</math></span> is found. The velocity dependence of the dissipation stress associated with the dislocation motion is then characterized and informed into the equation of motion of dislocation at the continuum level. A stationary dislocation motion below <span class="math"><math>τpmax</math></span> is attributed to: (i) the periodic lattice resistance smaller than <span class="math"><math>τpmax</math></span> almost everywhere; and (ii) the change of a dislocation's kinetic energy, which acts in a way equivalent to reducing <span class="math"><math>τpmax</math></span>. The results obtained here open up the possibilities of a dynamic intensification of plastic flow and defects accumulations, and consequently, the strain-induced phase transformations. Similar approaches can be applicable to partial dislocations, twin and phase interfaces.</p>
materials science, multidisciplinary,metallurgy & metallurgical engineering