Lasse Laurson,Jari Rosti,Juha Koivisto,Amandine Miksic,Mikko J. Alava
Abstract:We study the spatial fluctuations of transient creep deformation of materials as a function of time, both by Digital Image Correlation (DIC) measurements of paper samples and by numerical simulations of a crystal plasticity or discrete dislocation dynamics model. This model has a jamming or yielding phase transition, around which power-law or Andrade creep is found. During primary creep, the relative strength of the strain rate fluctuations increases with time in both cases - the spatially averaged creep rate obeys the Andrade law $\epsilon_t \sim t^{-0.7}$, while the time dependence of the spatial fluctuations of the local creep rates is given by $\Delta \epsilon_t \sim t^{-0.5}$. A similar scaling for the fluctuations is found in the logarithmic creep regime that is typically observed for lower applied stresses. We review briefly some classical theories of Andrade creep from the point of view of such spatial fluctuations. We consider these phenomenological, time-dependent creep laws in terms of a description based on a non-equilibrium phase transition separating evolving and frozen states of the system when the externally applied load is varied. Such an interpretation is discussed further by the data collapse of the local deformations in the spirit of absorbing state/depinning phase transitions, as well as deformation-deformation correlations and the width of the cumulative strain distributions. The results are also compared with the order parameter fluctuations observed close to the depinning transition of the 2$d$ Linear Interface Model or the quenched Edwards-Wilkinson equation.
What problem does this paper attempt to address?
The problem that this paper attempts to solve is to understand the characteristics of spatial fluctuations in materials during transient creep deformation. Specifically, the author studied the response of material samples under a constant load, especially the spatial fluctuations of the strain rate and their time - dependence. The research objects include paper samples and numerical simulations carried out by the digital image correlation (DIC) measurement method and the discrete dislocation dynamics (DDD) model.
### Core issues of the research
1. **Characteristics of strain - rate fluctuations during the creep process**:
- The author is concerned with how the strain - rate fluctuations in materials during the creep process change over time. In particular, during the primary creep stage, the average creep rate follows Andrade's law \( \epsilon_t \sim t^{-\theta} \), where \( \theta \approx 0.7 \).
- The spatial fluctuations of the strain rate show different time - dependences, with the standard deviation \( \Delta \epsilon_t \sim t^{-\gamma} \), where \( \gamma \approx 0.5 \).
2. **Importance of collective phenomena**:
- Research shows that during the primary creep stage, the relative intensity of strain - rate fluctuations increases with time, which means that the fluctuations become more and more important in a relative sense. This implies that collective phenomena may play a crucial role in the creep behavior of materials.
3. **Explanation of non - equilibrium phase transitions**:
- The author proposes an explanation based on non - equilibrium phase transitions, regarding creep deformation as a process approaching a non - equilibrium second - order phase transition. This explanation involves the transition of the system from a stationary state to an active state, similar to the absorbing state/depinning phase transition (AS/DP).
### Main research methods
- **Experimental part**:
- Experiments were carried out using paper samples, a constant load was applied, and the strain field was measured by the digital image correlation (DIC) method.
- The strain - rate fluctuations in different time periods were analyzed, and their time - dependence and spatial distribution were explored.
- **Numerical simulation**:
- The discrete dislocation dynamics (DDD) model was used to simulate two - dimensional shear deformation, taking into account the movement of point - like edge dislocations under the action of external shear stress.
- The simulation results showed the time - dependence of strain - rate fluctuations and were compared with the experimental results.
### Conclusions
Through the study of paper samples and the DDD model, the author found that the time - dependence of strain - rate fluctuations conforms to power - law decay, and the relative intensity of the fluctuations increases with time. These results indicate that collective phenomena during the creep process may be a key factor in determining material behavior. In addition, the author also proposed a theoretical explanation based on non - equilibrium phase transitions, providing a new perspective for further understanding the creep behavior of materials.
In summary, this paper aims to reveal the spatio - temporal characteristics of strain - rate fluctuations in materials during the creep process and explore the physical mechanisms behind these fluctuations.