Abstract:The possibility of using lasers to achieve previously unobtainable states of matter in the laboratory gained much attention following the demonstration of the first pulsed laser in 1960. In the following few years there was plenty research activity as attempts were made to increase the peak power and focused intensity in order to reach extreme conditions within the laboratory. Laser-acceleration technology is rapidly developing. Petawatt class lasers have been constructed for specific research activities, including particle acceleration, inertial confinement fusion and radiation therapy, and for secondary source generation (X rays, electrons, protons, neutrons and ions). As a new source of ionizing radiation, dose measurement in ultra-intense and ultra-short laser facilities is of great value for radiation protection of the environment, occupational staff and shielding design in laser device design stage. Owing to the pulsed and mixed characteristics of radiation field around the laser facility, it is really challenging to accurately measure the dose equivalent induced by bremsstrahlung photon in the target chamber of the laser facility. Moreover, the rationality of dose assessment model needs more experimental data and to be further verified. To reach this point, the Monte-Carlo program FLUKA was employed to characterize the radiation filed distribution. Firstly, a complete and thorough target chamber module was established according to the XG-Ⅲ geometry parameter and material composition. The in-chamber and out-chamber dose distribution were then calculated and analyzed based on the existing theoretical model of electron source term and typical experimental conditions. The electron energy distribution, characteristic electron temperature, scaling laws and laser-to-energy conversion efficiency were introduced. Secondly, the typical electron spectrum was divided into four intervals. The portion of different energy intervals to the total equivalent dose was determined. Thirdly, a bremsstrahlung photon dose equivalent measuring module was designed and optimized for ultra-intense and ultra-short laser facilities. The simulation results indicate that: 1) The electron dose equivalent is higher than the bremsstrahlung photons both inside and outside the target chamber; 2) The dose equivalent contribution of 0.15 MeV electron energy interval to the total energy range is dominant, and the module was design based on the conclusion; 3) The designed module mainly consists of PMMA and metallic shielding material. With this approach, the module can reduce the electron dose equivalent to 0.3% and photon dose equivalent to 69.1%. The dose ratio of electron to photon is about 128%. In addition, 5% of the total photon dose is contributed by the occurrence of bremsstrahlung of highenergy electron in PMMA.

FLUKA simulation validation to measure the beam energy of a cyclotron

FLUKA simulations of radionuclide yields in oblique targets

Measurement and Validation of the Cross Section in the FLUKA Code for the Production of 63 Zn and 65 Zn in Cu Targets for Low-Energy Proton Accelerators

Application of FLUKA to Simulate the Beam Loss Monitoring System for the Booster of the Shanghai Synchrotron Radiation Facility

Nuclear elastic scattering of protons below 250 MeV in FLUKA v4-4.0 and its role in single-event-upset production in electronics

Experimental validation of a FLUKA Monte Carlo simulation for carbon-ion radiotherapy monitoring via secondary ion tracking

FLUKA simulations of the target thickness dependence of Cu-K$β$/K$α$ intensity ratios

Induced radioactivity analysis for the NSRL Linac in China using Monte Carlo simulations and gamma-spectroscopy

Beam Simulation Studies of ECR Beam Extraction and Low Energy Beam Transport for FRIB.

Absolute dose calibration and output factor simulation for flattened and flattening filter-free Monte Carlo model of 6 MV photon beams

Comparison between Monte Carlo simulation and measurement of beam quality and output factor with flattened and flattening filter-free of linear accelerator

Experimental characterization of the optical klystron effect to measure the intrinsic energy spread of high-brightness electron beams

Converter thickness optimisation using Monte Carlo simulations of Fluorescent Nuclear Track Detectors for neutron dosimetry

Monte Carlo based absolute efficiency calibration of power reactor spent fuel NDA measurements

Experimental validation of a FLUKA Monte Carlo simulation for carbon‐ion radiotherapy monitoring via secondary ion tracking

STUDY ON THE SHIELDING AND DOSE RATE DISTRIBUTIONS OF THERAPEUTIC PROTON SYNCHROTRON ACCELERATOR BASED ON FLUKA

On the accuracy of Monte Carlo based beam dynamics models for the degrader in proton therapy facilities

Simulation of beam induced lattice defects of diamond detectors using FLUKA

Verification of TG-61 dose for synchrotron-produced monochromatic x-ray beams using fluence-normalized MCNP5 calculations

Beam Dynamics Simulation for the High Intensity DAEδALUS Cyclotrons

Study on Photon Dose of Ultra-intense and Ultra-short Laser Facility Based on Fully Monte-Carlo Simulation