Status Report on the Low-Energy Demonstration Accelerator (LEDA)

H. Vernon Smith Jr.,J. David Schneider

DOI: https://doi.org/10.48550/arXiv.physics/0008170

2000-08-19

Abstract:The 75-keV injector and 6.7-MeV RFQ that comprise the first portion of the cw, 100-mA proton linac for the accelerator production of tritium (APT) project have been built and operated. The LEDA RFQ has been extensively tested for pulsed and cw output-beam currents <=100 mA. Up to 2.2 MW of cw rf power from the 350-MHz rf system is coupled into the RFQ, including 670 kW for the cw proton beam. The emittance for a 93-mA pulsed RFQ output beam, as determined from quadrupole-magnet-scan measurements, is ex x ey = 0.25 x 0.31 (pi mm mrad)2 [rms normalized]. A follow-on experiment, to intentionally introduce and measure beam halo on the RFQ output beam, is now being installed.

Accelerator Physics

What problem does this paper attempt to address?

The problems that this paper attempts to solve mainly focus on verifying and optimizing the performance of the Low - Energy Demonstration Accelerator (LEDA), especially its Radio - Frequency Quadrupole (RFQ) part. Specifically, the main research objectives include:

1. **Verify the design code**: Ensure that the design code used to design the LEDA RFQ is accurate and reliable.
2. **Acquire manufacturing knowledge**: Accumulate relevant manufacturing experience and knowledge through the actual construction and testing of the LEDA RFQ.
3. **Understand beam operation**: Gain in - depth understanding of the transmission characteristics and behavior of the beam in the RFQ.
4. **Measure the output beam characteristics**: Accurately measure the characteristics of the proton beam output by the RFQ, such as emittance, transmission efficiency, etc.
5. **Reduce the beam interruption frequency**: Learn how to minimize the interruption problems that occur during beam transmission.
6. **Improve cost and availability predictions**: Provide more accurate cost and operational availability predictions for future larger - scale accelerators (such as the 1000 - 1700 MeV accelerator in the APT project).

### Specific problems and solutions

- **Beam transmission efficiency**: The study found that in the pulse mode, when the RFQ radio - frequency field strength is set to the design value, for an output beam greater than 90 mA, the transmission efficiency will suddenly drop after about 100 microseconds. To maintain high transmission efficiency, the radio - frequency field strength needs to be increased to 105 - 110% of the design value.

- **Beam emittance measurement**: Through quadrupole magnet scanning measurement, the emittance of a 93 mA pulsed beam was determined to be:
\[
\epsilon_x\times\epsilon_y = 0.25\times0.31(\pi\text{ mm mrad})^2
\]
These data are helpful for evaluating the quality and stability of the beam.

- **Beam halo experiment**: A new experimental device is being installed to intentionally introduce and measure the beam halo phenomenon in the RFQ output beam, so as to further understand the dynamic behavior of the beam.

In conclusion, through detailed operation results and data analysis, this paper aims to comprehensively verify and optimize the design and performance of the LEDA RFQ, and provide valuable experience and technical support for future larger - scale accelerator projects.