Modelling of the X-ray broad absorption features in Narrow-Line Seyfert 1s

D. Porquet,M. Mouchet,A.-M. Dumont

DOI: https://doi.org/10.48550/arXiv.astro-ph/0005169

2000-05-08

Abstract:We investigate the origin of the broad absorption features detected near 1-1.4 keV in several Narrow Line Seyfert 1 galaxies, by modelling the absorbing medium with various physical parameters, using the ionization code PEGAS. The observed properties of the X-ray absorption features can be reproduced by taking into account the peculiar soft X-ray excess which is well fitted by a blackbody plus an underlying power law. We equally stress that the emission coming from the absorbing medium (related to the covering factor) has a strong influence on the resulting X-ray spectrum, in particular on the apparent position and depth of the absorption features. A non-solar iron abundance may be required to explain the observed deep absorption. We also investigate the influence of an additional collisional ionization process (hybrid case) on the predicted absorption features.

Astrophysics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is about the origin of the broad - band absorption features detected in the 1 - 1.4 keV energy range in Narrow Line Seyfert 1 galaxies (NLS1s). Specifically, the authors explored the causes of these absorption features by modeling the absorbing media with different physical parameters, using the ionization code PEGAS. They paid special attention to the following points:

1. **The influence of the shape of the incident continuum**: NLS1s are stronger in soft X - ray emission compared to Broad Line Seyfert 1s (BLS1s), and usually have a steeper photon index. Their soft X - ray excess can be modeled as blackbody radiation superimposed on a basic power law. It was found that for a given ionization parameter \(\xi\) and hydrogen column density \(N_H\), this "typical NLS1 incident continuum" produces less absorption than a single power law, but has a higher ionization state, which may explain why the absorption features in NLS1s are located at higher energies.

2. **The influence of iron over - abundance**: Studies have shown that iron over - abundance may be the cause of strong absorption above 1 keV, while resulting in weaker oxygen absorption. Figure 1 shows the comparison between the transmission spectra when the iron over - abundance is 10 times the solar value and when it is the solar iron abundance.

3. **The influence of emission (covering factor)**: The intensity of the emission line depends on the covering factor (\(\varepsilon\propto f_c\)) of the medium responsible for absorption. Figure 2 illustrates the importance of the emission line to the observed spectral line, especially under different covering factors.

4. **The influence of collision processes**: Although the warm absorbers in BLS1s may be purely photo - ionized, additional ionization processes (such as collision or non - pure radiative equilibrium) are not excluded. This may also be the case in NLS1s. Figure 2 shows the different line ratios and absorption profiles in the case of pure photo - ionization and the mixed case (with the temperature fixed at \(3.6\times 10^6\) K).

Through these studies, the authors aim to understand the properties of the special soft X - ray spectra in NLS1s and the possible physical mechanisms behind these properties. This not only helps to explain the 1 keV absorption features in NLS1s, but may also provide constraints for the unified model.