Current-Biased Transition Edge Detector of $ \hbox{MgB}_{2}$ Nanowires for Neutrons: Imaging by Scanning Laser

I. Yagi,N. Yoshioka,H. Shishido,T. Yotsuya,S. Miki,Zhen Wang,T. Ishida
DOI: https://doi.org/10.1109/TASC.2013.2242193
IF: 1.9489
2013-01-22
IEEE Transactions on Applied Superconductivity
Abstract:The superconducting MgB<sub>2</sub> nanowire detector is biased by a current by a battery-class low voltage, and uses the nuclear reactions with a single neutron and the <sup>10</sup>B contained in MgB<sub>2</sub>. The MgB<sub>2</sub> detector consists of a 200-nm-thick MgB<sub>2</sub> thin film meander structure of 3 μm line width protected by 300-nm-thick SiO layer. We use enriched boron <sup>10</sup>B to enhance the sensitivity. The thermal energy of 2.3 MeV released by the reaction <sup>10</sup> B(<i>n</i>, α)<sup>7</sup>Li gives 1.83 MeV to <sup>4</sup>He and 0.47 MeV to <sup>7</sup>Li. The energy dissipation in a restricted space causes a local resistive state in the MgB<sub>2</sub> wire, which yields a subtle change in bias current. Through a mutual inductance connected in series with current-biased detector, we are able to measure the event as a voltage pulse. The position-dependent response of the MgB<sub>2</sub> detector is investigated by scanning a focused laser spot with the aid of an XYZ piezo-driven stage and an optical fiber with a focusing lens. A clear two-dimensional imaging pattern of the sensor signal well corresponds to the detector geometry. According to our results, the inhomogeneity and position-sensitive nature of the detector are supposed to be critical in governing the detection efficiency of the current-biased transition edge detector, which works only in the narrow temperature regime near <i>T</i><sub>c</sub>.
Materials Science
What problem does this paper attempt to address?