Abstract:Abstract High-pressure axial piston pumps operate in high-speed and high-pressure environments. The contact state of the slipper against the swashplate can easily change from an oil film lubrication to a mixed oil film/asperity contact, or even dry friction. To improve the dry friction performance of slipper pairs and to avoid their potentially rapid failure, this study examined the effects of material matching on the dry friction performance of the slipper pair for high-pressure axial piston pumps. A FAIAX6 friction and wear tester was developed, and the dry friction coefficients of the slipper pairs matched with different materials were studied using this tester. Based on the thermo-mechanical coupling of the slipper pair with the working process, the contact surface temperatures of the slipper pairs matched with different materials were calculated and analyzed for the same working conditions. Following this, the effects of the material properties on the temperature increase at the slipper sliding contact surfaces were revealed. The reliabilities of the temperature calculations and analysis results were verified through orthogonal tests of slipper pairs matched with different materials. The results indicate that the influence of the material density on the friction coefficient is greater than that of the Poisson’s ratio or the elastic modulus, and that the slipper material chosen should have a high thermal conductivity, low density, and low specific heat, whereas the swashplate material should be high in specific heat, density, and thermal conductivity; in addition, the slipper pair should be a type of hard material to match the type of soft material applied; that is, the hardness of the swashplate material should be greater than that of the slipper material.

Numerical Simulation on Lubrication and Experiment Study on Tribology Improvement of Slipper Pair at Low Speeds

Study on Friction Characteristics of Slipper Pair of Large Displacement High-Pressure Piston Pump

Analysis on dynamic experimental system of lubrication film properties of friction pairs in axial piston pump

Investigation on Structural Optimization of Anti-Overturning Slipper of Axial Piston Pump

Tribological Performance of MoS 2 Coating on Slipper Pair in Axial Piston Pump

Tribological performance of MoS2 coating on slipper pair in axial piston pump

Study on the Lubricating Characteristics of the Oil Film of the Slipper Pair in a Large Displacement Piston Pump

The Impact of Slipper Microstructure on Slipper-Swashplate Lubrication Interface in Axial Piston Pump.

A New Coupled Dynamic Model to Study the Vibration and Lubrication Characteristics of Slipper/Swash-Plate Interface in an Axial Piston Pump

Optimization Design Of The Inner Radius Of The Sealing Surface Of Slipper

Numerical Simulation of Overturning Phenomenon of Axial Piston Pump Slipper Pair

Theoretical and experimental study on lubrication and friction of slipper pair of valve distribution piston pump based on FVM-TRD coupling method

Simulation Study on Bearing Lubrication Mechanism and Friction Characteristics of the Biomimetic Non-Smooth Surface of a Cross-Scale, Second-Order Compound Microstructure

Novel Three-Piston Pump Design for a Slipper Test Rig

Experimental Investigate of the Wear and Friction Performance Considering Effects of Surface Topography and Lubricant

Multi-objective Optimization of Surface Texture for the Slipper/swash Plate Interface in EHA Pumps

A Mixed Lubrication Model for Predicting the Lubrication Performance Degradation Behavior of Slipper Pair in Early Wear Failure

Study on friction performance and mechanism of slipper pair under different paired materials in high-pressure axial piston pump

Wear Modelling of Slipper/swashplate Pair for Highspeed Piston Pump under Transient Lubrication Conditions

A New Method to Establish Coupled Multi-Physics Model of Lubricated Pin-Hole Oscillating Pair

Research on prediction methods for eccentric wear of the slipper pair in axial piston pumps and lubrication performance analysis