Abstract:The novel frictional properties of hydrogenated DLC (Diamond-like Carbon) films have been reported for nearly ten years. But up to now, researchers still haven’t known the exact mechanism resulting in the super-low frictional performance of hydrogenated DLC films. Especially they have little knowledge on the molecular configuration and structural properties of these kinds of films. In this paper, CH3 radicals with different impact energies are selected as source species to deposit DLC films on diamond (100) by molecular dynamics simulation. Results show hydrogenated DLC films can be successfully obtained when impact energy is in an appropriate scope that is no less than 20eV. The depositing processes involve impinging diamond surface and bonding procedure. Some atoms, instead of bonding with substrate atoms, fly away from the diamond surface. Only suitable impact energy can improve the growth of the film. Within 30eV to 60eV, the maximum deposition ratio is attained. In addition, when carbon atoms act as the deposition sources, the deposition ratio is relatively higher. Furthermore, the authors find that species with higher concentration of carbon atoms in deposition sources lead to a better deposition rate. Carbon atoms are more reactive than hydrogen atoms. Then the relative densities of DLC films are calculated. The density curves indicate that the structures of the films vary obviously as the impact energy augments. The average relative density is generally monotone increase with the increment of impact energy. The hybridization of carbon atoms greatly affects the properties of hydrogenated DLC films. The transition between sp2 and sp3 will result in the graphitization and reduce the frictional coefficient when DLC films are used as tribo-pair in friction.

Role of OH Termination in Mitigating Friction of Diamond-like Carbon under High Load: A Joint Simulation and Experimental Study

Effect of Carbon Diffusion on Friction and Wear Behaviors of Diamond-Like Carbon Coating Against Germanium in Boundary Base Oil Lubrication

Friction Between Diamond-Like Carbon (DLC) Films—a Molecular Dynamics Study

Running-in behavior of a H-DLC/Al2O3 pair at the nanoscale

Nanoscale friction of tetrahedral amorphous diamond-like carbon film after thermal annealing

Molecular Dynamics Studies on the Growth and Structural Properties of Hydrogenated DLC Films

Probing the friction mechanism of diamond-like carbon films in aqueous environments based on molecular dynamics simulations

Friction and Wear Performance of Hydrogenated Diamond-Like Coatings with Non-Metal Element Complex Dopants Against Alumina in Ambient Air

Synergistic effect of graphene and nanodiamonds to achieve ultra-low friction on rough DLC coatings

Friction And Wear Behavior Of Hydrogenated Diamond-Like Carbon Coating Against Titanium Alloys Under Large Normal Load And Variable Velocity

Effect of Sliding History on Super-Low Friction of Diamond-Like Carbon Coating in Water Lubrication

Preparation, Characterization and Investigation of Molecular Films Coated on Diamond-Like Carbon Substrate

Genesis of Superlow Friction in Strengthening Si-DLC/PLC Nanostructured Multilayer Films for Robust Superlubricity at Ultrahigh Contact Stress.

Tribological Performance of DLC Coatings Deposited by Ion Beam Deposition under Dry Friction and Oil Lubricated Conditions

A study of the wear mechanism of diamond-like carbon films

Vacuum Thermal Treatment for Achieving Macroscale Superlubricity by Nanodiamond and Hexagonal Boron Nitride on H‐DLC Film Surfaces in Dry Nitrogen

Understanding the friction behavior of sulfur-terminated diamond-like carbon films under high vacuum by first-principles calculations

Origin of Low Friction in Hydrogenated Diamond-Like Carbon Films Due to Graphene Nanoscroll Formation Depending on Sliding Mode: Unidirection and Reciprocation

The Effect of Carbon Structure of DLC Coatings on Friction Characteristics of MoDTC-Derived Tribofilm by Using an In Situ Reflectance Spectroscopy

Long-Duration Frictional and Wear Performance of the Diamond/DLC Bilayered Film under Water-Lubricating Condition

Frictional Properties of Element- and Compound-Doped Diamond-Like Carbon Films under Boundary Lubrication with Synthetic Base Oil