Comparative analysis of machinability characteristics of nitronic-50 using MT-CVD and MT-PVD inserts under dry conditions

Ayan Banerjee,Kalipada Maity

DOI: https://doi.org/10.1016/j.jmapro.2024.02.027

IF: 5.684

2024-04-01

Journal of Manufacturing Processes

Abstract:In quest of enhanced machinability, Nitronic-50 has been subjected to dry-turning operation with TiCN/Al2O3/TiCN coated MT-CVD and TiAlN/TiN coated MT-PVD inserts under three cutting speeds (50, 75 and 100 m/min), three feed rates (0.08, 0.1 and 0.12 mm/rev), and three depths of cut (0.1, 0.3, 0.5 mm) using Taguchi's L27 experimental design. Findings indicate that, compared to the highest values obtained with MT-CVD tools, use of MT-PVD tools in conjunction with an optimal parametric setting of low cutting speed-low feed-low depth of cut has resulted in lowering of surface roughness and tangential cutting force by 71.92% and 78.46% respectively. In contrast, reductions of 65.48%, 59.43%, and 75.42% are reported under the same optimized configuration with MT-CVD tools, in relation to the highest values of tool-tip temperature, chip-reduction coefficient, and flank wear depths respectively, obtained with MT-PVD inserts. Apparent coefficient of friction decreased by 46.83% upon using MT-CVD inserts at an optimal parametric configuration of moderate cutting speed, low feed, and low depth of cut, as compared to the highest values with MT-PVD inserts at higher settings. Overall, turning of Nitronic-50 in the specified domain is found to be significantly affected by cutting velocity and depth of cut.

engineering, manufacturing