Abstract:To avoid interference from unexpected background noises and obtain high fidelity voice signal, acoustic sensors with high sensitivity, flat frequency response, and high signal-to-noise ratio (SNR) are urgently needed for voice recognition. Graphene-oxide (GO) has received extensive attention due to its advantages of controllable thickness and high fracture strength. However, low mechanical sensitivity (S M ) introduced by undesirable initial stress limits the performance of GO material in the field of voice recognition. To alleviate the aforementioned issue, GO diaphragm with annular corrugations is proposed. By means of the reusable copper mold machined by picosecond laser, the fabrication and transfer of corrugated GO diaphragm are realized, thus achieving a Fabry–Perot (F–P) acoustic sensor. Benefitting from the structural advantage of the corrugated GO diaphragm, our F–P acoustic sensor exhibits high S M (43.70 nm/Pa@17 kHz), flat frequency response (−3.2 to 3.7 dB within 300–3500 Hz), and high SNR (76.66 dB@1 kHz). In addition, further acoustic measurements also demonstrate other merits, including an excellent frequency detection resolution (0.01 Hz) and high time stability (output relative variation less than 6.7% for 90 min). Given the merits presented before, the fabricated F–P acoustic sensor with corrugated GO diaphragm can serve as a high-fidelity platform for acoustic detection and voice recognition. In conjunction with the deep residual learning framework, high recognition accuracy of 98.4% is achieved by training and testing the data recorded by the fabricated F–P acoustic sensor.

Stable phase demodulation system for graphene oxide-based Fabry-Perot acoustic sensor

Coherent OTDR Based Ultra-High Sensitive Acoustic Sensor Assisted with Distributed Microstructured Optical Fiber(DMOF) and Hollow Cylinder Transducer

Highly Sensitive Graphene Oxide-Based Fabry-Perot Low-Frequency Acoustic Sensor With Low-Coherence Polarized Demodulation Using Three-Step Phase-Shifting Arctan Algorithms

Theoretical study of microfiber resonator devices exploiting a phase shift

Analysis of Graphene-Based Photonic Crystal Fiber Sensor Using Birefringence and Surface Plasmon Resonance

Acoustic Optical Fiber Sensor Based on Graphene Oxide Membrane

Humidity sensor based on core-offset fiber Mach-Zehnder interferometer coated graphene oxide film

Ultrastable cascaded LiNbO3 electro-optic modulation phase interrogation technique for Fabry-Perot acoustic sensors

High Sensitivity and High Stability Dual Fabry-Perot Interferometric Fiber-Optic Acoustic Sensor Based on Sandwich-Structure Composite Diaphragm

A Graphene-Enhanced Fiber-Optic Phase Modulator with Large Linear Dynamic Range

An Optical Acoustic Detection System Based on Fabry Pérot Etalon Stability Structure

Tunable Ultra‐High Q‐Factor and Figure of Merit based on Fano Resonance in Graphene–Dielectric Multilayer Corrugated Structure

Stabilization of optical Fabry–Perot sensor by active feedback control of diode laser

A Large-Area and Nanoscale Graphene Oxide Diaphragm-Based Extrinsic Fiber-Optic Fabry–Perot Acoustic Sensor Applied for Partial Discharge Detection in Air

Ultra-high sensitivity fiber optic microphone with corrugated graphene-oxide diaphragm for voice recognition

Evaluating a Human Ear-Inspired Sound Pressure Amplification Structure with Fabry–Perot Acoustic Sensor Using Graphene Diaphragm

Environmental Sensitivity of Fabry-Perot Microcavities Induced By Layered Graphene-Dielectric Hybrid Coatings

A dynamic spectral demodulation scheme of the fiber optical Fabry-Perot sensor for low-frequency vibration detection

Graphene-Based Fully Transparent Thin Film Surface Acoustic Wave Devices for Sensing and Lab-on-Chip Applications

Optical fiber sensor based on porous graphene (PG) and graphene oxide (GO)

Flexible Optical Fiber Fabry–Perot Interferometer Based Acoustic and Mechanical Vibration Sensor