Abstract:Full‐field optical experimental techniques such as Digital Image Correlation (DIC) enable measurement of information‐rich heterogeneous strain states. The aim of Material Testing 2.0 is to capitalise on this and design experimental setups for efficient material characterisation using inverse identification techniques such as the Virtual Fields Method (VFM). In that case, however, a priori knowledge of the constitutive model is required, which sometimes is not a trivial task. This limitation can be overcome by identifying multiple constitutive models using the same DIC strain fields and comparing their performance. In this work, we present a methodology to evaluate model performance and compare different constitutive models based on quantitative metrics. DIC experiments were performed on an S‐shaped high density polyethylene test sample under uniaxial load. The heterogeneous DIC strain fields were used in combination with the VFM to identify parameters of hyperelastic constitutive models with increasing complexity. Two deterministic metrics, the equilibrium gap indicator (EGI) and the reconstructed axial force ratio (RAFR), were defined and used to compare the performance of these constitutive models. The impact of spatial smoothing on DIC strain fields was studied by calculating the EGI and RAFR using a digital twin of the DIC experiments. EGI and RAFR metrics provide complementary information regarding the material behaviour, and both are necessary to make an informed choice. In this case study, hyperelastic constitutive models were found not to capture the material stiffness well in the small strain regime. A linear‐elastic contribution exponentially decaying with the equivalent shear stress was added to the hyperelastic models and the corresponding model parameters identified using the VFM. The elastic‐hyperelastic constitutive models were found to perform better than their purely hyperelastic counterparts.

Material Characterization of Hybrid Composite: Experimental Using Strain Gauge/DIC with Finite Element Modelling Macro/Micro Scale

Micro Failure Analysis of Fiber Metal Laminates

Strain Measuring of Composite Grid Using Digital Image Correlation

Simulation of the Hybrid Carbon-Aramid Composite Materials Based on Mechanical Characterization by Digital Image Correlation Method

Multi-Scale Experimental Characterization for LS-DYNA MAT213 Modeling of Composite Structures under High Strain Rate

Pre-use Interfacial Shear Strength Prediction for Fiber-Reinforced Thermosetting Composites Based on Stress-Impedance Effect of Ferromagnetic Microwires

Metrics to evaluate constitutive model fitness based on DIC experiments

Characterization for elastic constants of fused deposition modelling-fabricated materials based on the virtual fields method and digital image correlation

Study of Structural Composite Joint Damage by the Digital Image Correlation

Elastic Property Evaluation of Fiberglass and Epoxy Resin Composite Material Using Digital Image Correlation

Digital Image Correlation Analysis of Strain Fields in Fibre-Reinforced Polymer–Matrix Composite under ±45° Off-Axis Tensile Testing

Nondestructive evaluation of carbon-fiber composites using digital image correlation, acoustic emission, and optical based modal analysis

Experimental Data on Fracture of Open-Hole Composite Laminates Subjected to Tension Loading

Prediction of the failure behavior of pseudo-ductile composites using a multi-scale finite element model

Experimental investigation on open-hole CFRP laminate under combined loading using acoustic emission and digital image correlation

Numerical Analysis of Unidirectional GFRP Composite Mechanical Response Subjected to Tension Load using Finite Element Method

Experimental and Numerical Investigation of the Mechanical Properties of 3D-Printed Hybrid and Non-Hybrid Composites

Integrated Digital Image Correlation for Micro-Mechanical Parameter Identification in Multiscale Experiments

Experimental and numerical investigation of heterogeneous strain fields in intralayer hybrid composites with aramid-carbon reinforcement

Strain Measurement with Optic Fibers for Structural Health Monitoring of Woven Composites: Comparison with Strain Gauges and Digital Image Correlation Measurements

DIC Based Strain and Damage Analysis of Large Scale Steel to Composite Adhesive Joints Subjected to Tension and Compression Loading