Study on the Partial Paste Backfill Mining Method in a Fully Mechanized Top-Coal Caving Face: Case Study from a Coal Mine, China

Zhaowen Du,Deyou Chen,Xuelong Li,Yong Jian,Weizhao Zhang,Dingding Zhang,Yongfeng Tian
DOI: https://doi.org/10.3390/su16114393
IF: 3.9
2024-05-23
Sustainability
Abstract:Paste backfill mining is an significant part of green coal mining, which can improve resource utilization and extend the service life of mines. It is important for solving the "three under, one above" mining problem and avoiding industrial wastes such as coal gangue and fly ash that occupy farmland and pollute the environment. To address the difficult filling problem of a fully mechanized top-coal caving face (FMT-CCF), a new method of partial paste backfill mining is herein proposed. First, the partial paste backfill mining method and implementation steps of the FMT-CCF are introduced in detail. Then, the mechanistic model of the roof beam in partial paste backfill mining is established. Then, the filling structural factors on the filling effect of the 42105 FMT-CCF are determined. Dependent on the assay of the migration law of overlying stratum after filling, numerical simulation analysis is used to research the feature effect of the main filling structural factors on the filling effect. Finally, the paste filling rate, filling width, and filling strength suitable for the 42105 FMT-CCF are obtained. When the filling rate reaches 100%, a significant alteration takes place, resulting in the efficient decrease of the overlying rock stress arch shell's height. As the width of the filling body expands from 10 m at each end to 20 m, the stress arch of the overlying rock experiences maximum reduction, specifically decreasing by approximately 14 m. When the strength of the filling body is greater than 0.4 GPa, the filling effect is better. This study has important guidance and reference significance for the partial paste backfill of FMT-CCF in thick seam mining.
environmental sciences,environmental studies,green & sustainable science & technology
What problem does this paper attempt to address?
This paper mainly discusses the application of partial paste backfill mining method in fully-mechanized top coal caving working face. The environmental problems caused by coal mining, such as surface subsidence, building damage, and water resource loss, are due to the instability of overlying strata caused by mining. Paste backfill technology is an important part of green coal mining, which can improve resource utilization, extend mine life, and reduce industrial waste pollution to farmland and the environment. To solve the difficulty of filling in fully-mechanized top coal caving working face, this paper proposes a new method of partial paste backfill mining. Firstly, the implementation steps of this method are detailed, a mechanical model of the top beam in partial paste backfill mining is established, and the main filling structural factors that affect the filling effect of 42105 working face are determined. The influence of these factors on the filling effect is analyzed through simulation. The results show that the paste filling rate, filling width, and filling material strength are key factors. When the filling rate reaches 100%, the height of overlying stress arch can be significantly reduced. When the filling width expands from 10 meters at both ends to 20 meters, the overlying stress arch decreases the most, with a decrease of approximately 14 meters. The filling effect is the best when the filling material strength is greater than 0.4 GPa. The paper also reviews previous research on backfill mining under special conditions, and points out that although there have been studies, backfilling for fully-mechanized top coal caving working face is still a relatively less studied field. The paper proposes a new partial paste backfilling method suitable for this working face, aiming to solve the filling challenge with limited space, improve stability, reduce ground collapse, and effectively manage solid waste. Through theoretical analysis and numerical simulation, the influence of filling structural factors on the filling effect is studied, providing a scientific basis for future filling mining in similar working faces.