Abstract:This article presents the results of the theoretical and experimental studies of frequency tuning in the -band low-voltage magnetron with two energy outputs. The principal condition of applying the magnetron is the application of the short-circuit piston as a reactive load of the second (passive) energy output. For theoretical investigation, we used two mathematical models of the magnetron: the simple analytical model for simulation of the "cold" anode block in one-wave approximation using the equivalent circuit method and the 3-D model of the magnetron using the particle-in-cell (PIC) method. It is shown that the necessary condition for frequency tuning in such magnetrons is a request to design the anode block when the coupling of the passive RF output with the anode block exceeds the analogous coupling between the anode block and the active RF output. The numerical experiment shows the more complicated nonlinear mechanism for limiting the frequency tuning band. It has been found that a reason for such limitation is conditioned by competition of operating -mode with the closest in the frequency of additionally excited resonant high- and low-frequency -modes. For the experimental investigation, we used the prototype of the magnetron having the following operating parameters: the central frequency is 9.38 GHz, the anode voltages are V, the axial magnetic field is 0.21 T, the indirect heater cathode and the forced-air cooling. As a result, at maximum output power of ~18 W and efficiency of ~37%, the frequency tuning full range was ~320 MHz.

Modeling and Experiments of an Injection-Locked Magnetron With Various Load Reflection Levels

New Experimental Results Obtained using Microwave Reflectometry in HL-2 A Tokamak

Analysis Of The Injection-Locked Magnetron With A Mismatched Circulator

Injection-Locking of Magnetrons with Matched Impedance

A Magnetron Using an Additional External Reactive Load for Frequency Tuning: Theory Features and Experiment

Theoretical investigation of frequency characteristics of free oscillation and injection-locked magnetrons*

3d Particle-In-Cell Simulation Of Continuous Wave Magnetron

The Interlocking Experiment on Millimeter Wave Coaxial Magnetron for Array Application

Investigation on Thermal Efficiency Enhancement and Sideband Emission Suppression for Magnetron Injection Gun

Simulation and Experiment Measurement of High Power Continuous Wave Magnetron

First Demonstration and Performance of X-Band High-Power Magnetron With Parallel Cathodes

Three dimension PIC simulations of A 2.45GHz injection-locked magnetron with sector-and-slot-type resonators

Coherent Power Combining of Four-Way Injection-Locked 5.8-GHz Magnetrons Based on a Five-Port Hybrid Waveguide Combiner

Electron Transportation Experiment and Analysis for a G-Band Magnetron Injection Gun

Sweep Frequency Heating based on Injection Locked Magnetron

Theoretical Analysis And Simulation Of Resonant System Of High Power Continuous Wave Magnetron

Design and Experiment of a Compact Magnetron Injection Gun for a Coil Magnet $\textit{X}$-Band Gyro-TWT

Modeling and optimization of a relativistic magnetron with transparent cathode and output mode

Design of a Simultaneous Information and Power Transfer System Based on a Modulating Feature of Magnetron

Internal-locking relativistic magnetron in transversely opposed driven scheme

Experimental Study of Magnetron's Power-Pulled Characteristic to Realize a Quasi-Dual-Frequency Microwave Output