Computational study on the impact of gasoline-ethanol blending on autoignition and soot/NOx emissions under low-load gasoline compression ignition conditions
Krishna C. Kalvakala,Harsimran Singh,Pinaki Pal,Jorge Pulpeiro Gonzalez,Christopher P. Kolodziej,Suresh K. Aggarwal
DOI: https://doi.org/10.1177/14680874241286268
2024-10-12
International Journal of Engine Research
Abstract:International Journal of Engine Research, Ahead of Print. In the present work, computational fluid dynamics (CFD) simulations of a single-cylinder gasoline compression ignition (GCI) engine are performed to investigate the impact of gasoline-ethanol blending on autoignition, nitrogen oxide (NOx), and soot emissions under low-load conditions. In order to represent the test gasoline (RD5-87), a four-component toluene primary reference fuel (TPRF)+ethanol (ETPRF) surrogate (with 10% ethanol by volume; E10) is employed. A three-dimensional (3D) engine CFD model employing finite-rate chemistry with a skeletal kinetic mechanism (including NOx sub-mechanism), adaptive mesh refinement (AMR), and hybrid method of moments (HMOM) is adopted to capture the in-cylinder combustion phenomena and soot/NOx emissions. The engine CFD model is validated against experimental data for three gasoline-ethanol blends: E10, E30 and E100, with varying ethanol content by volume. Model validation is carried out for a broad range of start-of-injection (SOI) timings (−21, −27, −36, and −45 crank angle degrees (°CA) after top-dead-center (aTDC)) with respect to in-cylinder pressure, heat release rate, combustion phasing, NOx and soot emissions. For relatively later injection timings (−21 and −27 °CA aTDC), E30 yields higher amount of soot than E10; while the trend reverses for early injection cases (−36 and −45 °CA aTDC ). On the other hand, E100 yields the lowest amount of soot among all fuels irrespective of SOI timing. Further, E10 shows a non-monotonic trend in soot emissions with SOI timing: SOI-36>SOI-45>SOI-21>SOI-27, while soot emissions from E30 exhibit monotonic decrease with advancing SOI timing. NOx emissions from various fuels follow a trend of E10>E30>E100. On the other hand, NOx emissions increase as SOI timing is advanced for all fuels, with an anomaly for E10 and E100 where NOx decreases when SOI is advanced beyond −36 °CA aTDC. Detailed analysis of the numerical results is performed to investigate the soot/NOx emission trends and elucidate the impact of chemical composition and physical properties on autoignition and emissions characteristics.