Jetting during oblique impacts of spherical impactors

Shigeru Wakita,Brandon C. Johnson,C. Adeene Denton,Thomas M. Davison
DOI: https://doi.org/10.1016/j.icarus.2021.114365
IF: 3.657
2021-05-01
Icarus
Abstract:<p>During the early stages of an impact a small amount material may be jetted and ejected at speeds exceeding the impact velocity. Jetting is an important process for producing melt during relatively low velocity impacts. <strong>How impact angle affects the jetting process has yet to be fully understood.</strong> Here, we simulate jetting during oblique impacts using the iSALE shock physics code. <strong>Assuming both the target and impactor have the same composition (dunite), we examine the jetted material which exceeds the impact velocity.</strong> Our results show that oblique impacts always produce more jetted ejecta than vertical impacts, except for grazing impacts with impact angles <span class="math"><math>&lt;</math></span>15°. A 45°impact with an impact velocity of 3 km/s produces jetted material equal to <span class="math"><math>∼</math></span>7% of the impactor mass. This is 6 times the jetted mass produced by a vertical impact with similar impact conditions. We also find that the origin of jetted ejecta depends on impact angle; for impact angles less than 45°, most of the jet is composed of impactor material, while at higher impact angles the jet is dominated by target material. <strong>Our findings are consistent with previous experimental work.</strong> In all cases, jetted materials are preferentially distributed downrange of the impactor.</p>
astronomy & astrophysics
What problem does this paper attempt to address?