Abstract:Background: Combined infrared (CIR) and convective drying is a promising technology in dehydrating heat-sensitive foods, such as fruits and vegetables. This novel thermal drying method, which involves the application of infrared energy and hot air during a drying process, can drastically enhance energy efficiency and improve overall product quality at the end of the process. Understanding the dynamics of what goes on inside the product during drying is important for further development, optimization, and upscaling of the drying method. In this study, a multiphase porous media model considering liquid water, gases, and solid matrix was developed for the CIR and hot-air drying (HAD) of sweet potato slices in order to capture the relevant physics and obtain an in-depth insight on the drying process. The model was simulated using Matlab with user-friendly graphical user interface for easy coupling and faster computational time. Results: The gas pressure for CIR-HAD was higher centrally and decreased gradually towards the surface of the product. This implies that drying force is stronger at the product core than at the product surface. A phase change from liquid water to vapour occurs almost immediately after the start of the drying process for CIR-HAD. The evaporation rate, as expected, was observed to increase with increased drying time. Evaporation during CIR-HAD increased with increasing distance from the centreline of the sample surface. The simulation results of water and vapour flux revealed that moisture transport around the surfaces and sides of the sample is as a result of capillary diffusion, binary diffusion, and gas pressure in both the vertical and horizontal directions. The nonuniform dominant infrared heating caused the heterogeneous distribution of product temperature. These results suggest that CIR-HAD of food occurs in a non-uniform manner with high vapour and water concentration gradient between the product core and the surface. Conclusions: This study provides in-depth insight into the physics and phase changes of food during CIR-HAD. The multiphase model has the advantage that phase change and impact of CIR-HAD operating parameters can be swiftly quantified. Such a modelling approach is thereby significant for further development and process optimization of CIR-HAD towards industrial upscaling. © 2020 Society of Chemical Industry.

SOFTWARE FOR PARAMETER ESTIMATION IN THIN–LAYER DRYING MODELS

Semi-empirical thin-layer drying model for the agricultural products

Implementation of Parameter Estimation in Mechanistic Models by Dynamic Optimization

RSM As an Approach to Optimize Ginger Intermittent Microwave Drying Process

A comprehensive review of thin-layer drying models used in agricultural products

A fully coupled multiphase model for infrared-convective drying of sweet potato

Mass-Transfer Simulation Software Study of Sliced Porous Production During Convection Drying Process

Effect of drying kinetics model on energy efficiency of drying systems

ESTIMATION OF THIN-LAYER DRYING KINETICS OF UNDERUTILIZED PEA PODS USING PAGE’S MODEL

Modeling of Muti-layer Far-Infrared Dryer

Kinetic Parameter Estimation for Linear Low-Density Polyethylene Gas-Phase Process from Molecular Weight Distribution and Short-Chain Branching Distribution Measurements

Mathematical Modeling of Thin-Layer Drying Kinetics of Tomato Peels: Influence of Drying Temperature on the Energy Requirements and Extracts Quality

Optimization Method for the Evaluation of Convective Heat and Mass Transfer Effective Coefficients and Energy Sources in Drying Processes

Forecast Analyzing on Thin Layer Drying of Radish Strip and Experiment

Modeling of drying kinetics of green peas by reaction engineering approach

Iterative method for fast estimation of convective drying characteristics of biomass

Heat and Mass Transfer, Quality, Performance Analysis, and Modeling of Thin Layer Drying Kinetics of Banana Slices

On-line evaluation of moisture transfer properties for a feed-forward control of a wood drying kiln with a mechanistic model

Application of modified temperature-moisture relationships in the calculations of drying kinetics

Modeling and simulation of drying kinetics/curves: application to building materials

Computer Vision Application on Controlling and Modeling the Food Drying Process: A Case Study for Radish (Raphanus Sativus)