Abstract:In non-conforming rolling contact, the contact stress is highly concentrated in the contact area. However, there are some limitations of the special contact model and stress model used for the theoretical study of the phenomenon, and this has prevented in-depth analysis of the associated friction, wear, and failure. This paper is particularly aimed at investigating the area of rolling contact between a sphere and a cone, for which purpose the boundary is determined by the Hertz theory and the geometries of the non-conforming surfaces. The phenomenon of stick-slip contact is observed to occur in the contact area under the condition of no-full-slip (Q < μ · P). Using the two-dimensional rolling contact theory developed by CARTER, the relative positions of the stick and slip regions and the distribution of the tangential force over the contact area are analyzed. Furthermore, each stress component is calculated based on the McEwen theory and the idea of narrow band. The stress equations for the three-dimensional rolling contact between the sphere and the cone are obtained by the principle of superposition, and are used to perform some numerical simulations. The results show that the stress components have a large gradient along the boundary between the stick and slip regions, and that the maximum stress is inversely proportional to the contact coefficient and proportional to the friction coefficient. A new method for investigating the stress during non-classical three-dimensional rolling contact is proposed as a theoretical foundation for the analysis of the associated friction, wear, and failure.

On adhesive contact between spheres with rolling adhesion

A Model of Adhesive Contact Between a Cylinder and a Substrate under Mixed-Mode Loading with Effect of Rolling Adhesion

A Numerical Study of the Rolling Friction Between a Microsphere and a Substrate Considering the Adhesive Effect

A Molecular Dynamics Simulation Based Double-Hertz Model for Inclined Adhesive Contact Between Spheres

A Molecular Dynamics Study on the Adhesive Contact with Effect of Tangential Forces

Application of J-integral to Adhesive Contact under General Plane Loading for Rolling Resistance

A Mechanical Model for the Adhesive Contact with Local Sliding Induced by a Tangential Force

Mechanical Models for the Adhesive Friction of Nano- and Micro-Particles

Modeling the Role of Interfacial Adhesion in the Rolling Resistance of a Hyperelastic Wheel

Adhesive Contact on Randomly Rough Surfaces Based on the Double-Hertz Model

Non-Slipping Adhesive Contact Between Dissimilar Elastic Solids under Normal and Tangential Loads

Analysis and Numerical Simulation of Rolling Contact Between Sphere and Cone

Adhesive Contact: from Atomistic Model to Continuum Model

Adhesive Contact Model and Calculation of Micro-Mechanical Systems

A Double-Hertz Model for Adhesive Contact Between Cylinders under Inclined Forces

Adhesion between elastic cylinders based on the double-Hertz model

Rolling, sliding and torsion of micron-sized silica particles: experimental, numerical and theoretical analysis

Effect of Surface Tension on the Behavior of Adhesive Contact Based on Maugis‒Dugdale Model

Adhesive transition from noncontacting to contacting elastic spheres: extension of the Maugis-Dugdale model.

Elastic Model of Adhesive Contact Based on Hamaker Hypotheses

A Model for Computational Investigation of Elasto-Plastic Normal and Tangential Contact Considering Adhesion Effect