Abstract:Abstract. The Community Multiscale Air Quality (CMAQ) model is a comprehensive multipollutant air quality modeling system developed and maintained by the US Environmental Protection Agency's (EPA) Office of Research and Development (ORD). Recently, version 5.1 of the CMAQ model (v5.1) was released to the public, incorporating a large number of science updates and extended capabilities over the previous release version of the model (v5.0.2). These updates include the following: improvements in the meteorological calculations in both CMAQ and the Weather Research and Forecast (WRF) model used to provide meteorological fields to CMAQ, updates to the gas and aerosol chemistry, revisions to the calculations of clouds and photolysis, and improvements to the dry and wet deposition in the model. Sensitivity simulations isolating several of the major updates to the modeling system show that changes to the meteorological calculations result in enhanced afternoon and early evening mixing in the model, periods when the model historically underestimates mixing. This enhanced mixing results in higher ozone (O3) mixing ratios on average due to reduced NO titration, and lower fine particulate matter (PM2. 5) concentrations due to greater dilution of primary pollutants (e.g., elemental and organic carbon). Updates to the clouds and photolysis calculations greatly improve consistency between the WRF and CMAQ models and result in generally higher O3 mixing ratios, primarily due to reduced cloudiness and attenuation of photolysis in the model. Updates to the aerosol chemistry result in higher secondary organic aerosol (SOA) concentrations in the summer, thereby reducing summertime PM2. 5 bias (PM2. 5 is typically underestimated by CMAQ in the summer), while updates to the gas chemistry result in slightly higher O3 and PM2. 5 on average in January and July. Overall, the seasonal variation in simulated PM2. 5 generally improves in CMAQv5.1 (when considering all model updates), as simulated PM2. 5 concentrations decrease in the winter (when PM2. 5 is generally overestimated by CMAQ) and increase in the summer (when PM2. 5 is generally underestimated by CMAQ). Ozone mixing ratios are higher on average with v5.1 vs. v5.0.2, resulting in higher O3 mean bias, as O3 tends to be overestimated by CMAQ throughout most of the year (especially at locations where the observed O3 is low); however, O3 correlation is largely improved with v5.1. Sensitivity simulations for several hypothetical emission reduction scenarios show that v5.1 tends to be slightly more responsive to reductions in NOx (NO + NO2), VOC and SOx (SO2 + SO4) emissions than v5.0.2, representing an improvement as previous studies have shown CMAQ to underestimate the observed reduction in O3 due to large, widespread reductions in observed emissions.

A performance evaluation of the 2004 release of Models-3 CMAQ

Examination of the Community Multiscale Air Quality (CMAQ) model performance over the North American and European domains

Models‐3 Community Multiscale Air Quality (CMAQ) model aerosol component 2. Model evaluation

An Annual Evaluation of Models-3 CMAQ Using a 2001 Simulation

Performance and diagnostic evaluation of ozone predictions by the Eta-Community Multiscale Air Quality Forecast System during the 2002 New England Air Quality Study.

A Detailed Evaluation of the Eta‐CMAQ Forecast Model Performance for O3, Its Related Precursors, and Meteorological Parameters During the 2004 ICARTT Study

Evaluation of the community multiscale air quality (CMAQ) model version 4.5: Sensitivities impacting model performance; Part II—particulate matter

A comparative performance evaluation of the AURAMS and CMAQ air-quality modelling systems

Dynamic evaluation of CMAQ part I: Separating the effects of changing emissions and changing meteorology on ozone levels between 2002 and 2005 in the eastern US

Description and evaluation of the Community Multiscale Air Quality (CMAQ) modeling system version 5.1

Comparative Evaluation of the Impact of Wrf-Nmm and Wrf-Arw Meteorology on Cmaq Simulations for O-3 and Related Species During the 2006 Texaqs/Gomaccs Campaign

Evaluation of Real‐time PM2.5 Forecasts and Process Analysis for PM2.5 Formation over the Eastern United States Using the Eta‐CMAQ Forecast Model During the 2004 ICARTT Study

Incremental testing of the Community Multiscale Air Quality (CMAQ) modeling system version 4.7

Understanding of regional air pollution over China using CMAQ, part I performance evaluation and seasonal variation

A comparison of CMAQ-based and observation-based statistical models relating ozone to meteorological parameters

Comparative evaluation of the impact of WRF/NMM and WRF/ARW meteorology on CMAQ simulations for PM2.5 and its related precursors during the 2006 TexAQS/GoMACCS study

A comparative study of two-way and offline coupled WRF v3.4 and CMAQ v5.0.2 over the contiguous US: performance evaluation and impacts of chemistry-meteorology feedbacks on air quality

Study of statistically correcting model CMAQ-MOS for forecasting regional air quality

One-year simulation of ozone and particulate matter in Chinausing WRF/CMAQ modeling system

A performance evaluation of the National Air Quality Forecast Capability for the summer of 2007☆

One-year simulation of ozone and particulate matter in China using WRF/CMAQ modeling system