Abstract:Abstract. The Community Multiscale Air Quality (CMAQ) model is a comprehensive multipollutant air quality modeling system developed and maintained by the US Environmental Protection Agency's (EPA) Office of Research and Development (ORD). Recently, version 5.1 of the CMAQ model (v5.1) was released to the public, incorporating a large number of science updates and extended capabilities over the previous release version of the model (v5.0.2). These updates include the following: improvements in the meteorological calculations in both CMAQ and the Weather Research and Forecast (WRF) model used to provide meteorological fields to CMAQ, updates to the gas and aerosol chemistry, revisions to the calculations of clouds and photolysis, and improvements to the dry and wet deposition in the model. Sensitivity simulations isolating several of the major updates to the modeling system show that changes to the meteorological calculations result in enhanced afternoon and early evening mixing in the model, periods when the model historically underestimates mixing. This enhanced mixing results in higher ozone (O3) mixing ratios on average due to reduced NO titration, and lower fine particulate matter (PM2. 5) concentrations due to greater dilution of primary pollutants (e.g., elemental and organic carbon). Updates to the clouds and photolysis calculations greatly improve consistency between the WRF and CMAQ models and result in generally higher O3 mixing ratios, primarily due to reduced cloudiness and attenuation of photolysis in the model. Updates to the aerosol chemistry result in higher secondary organic aerosol (SOA) concentrations in the summer, thereby reducing summertime PM2. 5 bias (PM2. 5 is typically underestimated by CMAQ in the summer), while updates to the gas chemistry result in slightly higher O3 and PM2. 5 on average in January and July. Overall, the seasonal variation in simulated PM2. 5 generally improves in CMAQv5.1 (when considering all model updates), as simulated PM2. 5 concentrations decrease in the winter (when PM2. 5 is generally overestimated by CMAQ) and increase in the summer (when PM2. 5 is generally underestimated by CMAQ). Ozone mixing ratios are higher on average with v5.1 vs. v5.0.2, resulting in higher O3 mean bias, as O3 tends to be overestimated by CMAQ throughout most of the year (especially at locations where the observed O3 is low); however, O3 correlation is largely improved with v5.1. Sensitivity simulations for several hypothetical emission reduction scenarios show that v5.1 tends to be slightly more responsive to reductions in NOx (NO + NO2), VOC and SOx (SO2 + SO4) emissions than v5.0.2, representing an improvement as previous studies have shown CMAQ to underestimate the observed reduction in O3 due to large, widespread reductions in observed emissions.

An Annual Evaluation of Models-3 CMAQ Using a 2001 Simulation

Modeling Study on Atmospheric Environmental Capacity of Major Pollutants Constrained by PM_(2.5) Compliance of Chinese Cities

A performance evaluation of the 2004 release of Models-3 CMAQ

Description and evaluation of the Community Multiscale Air Quality (CMAQ) modeling system version 5.1

Review of the Governing Equations, Computational Algorithms, and Other Components of the Models-3 Community Multiscale Air Quality (CMAQ) Modeling System

Models‐3 Community Multiscale Air Quality (CMAQ) model aerosol component 2. Model evaluation

A review of the CAMx, CMAQ, WRF-Chem and NAQPMS models: Application, evaluation and uncertainty factors

Dynamic evaluation of CMAQ part I: Separating the effects of changing emissions and changing meteorology on ozone levels between 2002 and 2005 in the eastern US

Examination of the Community Multiscale Air Quality (CMAQ) model performance over the North American and European domains

Use of a process analysis tool for diagnostic study on fine particulate matter predictions in the U.S. - Part I: Model evaluation

One-year simulation of ozone and particulate matter in Chinausing WRF/CMAQ modeling system

The importance of spatial resolutions of Community Multiscale Air Quality (CMAQ) models on health impact assessment

Study of statistically correcting model CMAQ-MOS for forecasting regional air quality

One-year simulation of ozone and particulate matter in China using WRF/CMAQ modeling system

Evaluation of the community multiscale air quality (CMAQ) model version 4.5: Sensitivities impacting model performance; Part II—particulate matter

Development of the MPAS-CMAQ Coupled System (V1.0) for Multiscale Global Air Quality Modeling

An updated modeling framework to simulate Los Angeles air quality – Part 1: Model development, evaluation, and source apportionment

Use of a process analysis tool for diagnostic study on fine particulate matter predictions in the U.S.-Part II: Analyses and sensitivity simulations

Evaluation of Real‐time PM2.5 Forecasts and Process Analysis for PM2.5 Formation over the Eastern United States Using the Eta‐CMAQ Forecast Model During the 2004 ICARTT Study

A Comprehensive Performance Evaluation of MM5-CMAQ for the Summer 1999 Southern Oxidants Study Episode—part II: Gas and Aerosol Predictions

Study on the 3dvar Emission Inversion Method Combined with Machine Learning in CMAQ