Abstract:Photoelectrochemical water splitting (PEC) is a viable solution for addressing future environmental and energy concerns. However, due to the high cost of photoelectrodes and the limitations of sluggish kinetics, practical applications are limited. To achieve that goal, effective solutions are still needed to create low-cost photoelectrodes suited for PEC. Transistion metal sulfides (TMS) materials have a high potential for use as photoelectrodes due to their favorable and impressive properties 1 . The photoactivity of TMS is typically unlimited due to low reflection at the grain boundary. The individual atomic thin sheets with higher surface area compared to bulk materials allow for faster diffusion of photoinduced charge carriers primarily due to the less interface between their grains. Their lower interfacial contact resistance enables enhanced charge dynamics and, as a result, improved electrochemical reaction kinetics. When compared to other TMS, CdS has a direct bandgap and excellent photoactivity. However, its toxicity and photocorrosion make it unsuitable for long-term practical use. WS 2 is well-known layered transition metal sulfide that has a 2D molybdenite structure. It is non-toxic in acidic/neutral solutions that are chemically stable. It has been demonstrated to be more stable against oxidation and photo corrosion than CdS, which is extensively employed in photocatalysis 2 . However, because of the recombination of photoinduced charge carriers, pure WS 2 exhibits relatively poor photocatalytic efficiency and stability. As a result, combining WS 2 based photoactive nanomaterials with other suitable materials has helped overcome this challenge. Transistion metal sulfides with acceptable band structures for heterostructure construction with WS 2 may enable breakthroughs in photocatalytic and photo-electrochemical processes. The primary focus of this work is to construct heterostructures by combining CdS and WS 2 and to investigate their role as photoanodes of semiconductor materials in PEC water splitting. In this work, we have synthesised heterostructures using a facile solution-reaction method and Successive Ionic Layer Adsorption Reaction deposition (SILAR) technique which is intrinsically cost effective and scalable 3 . The heterostructure is characterised by XRD, SEM and TEM. We also studied the performance enhancement of this heterostructure using Linear sweep voltammetry and Electrochemical impedance spectroscopy. Pristine WS 2 and CdS showed photocurrent densities of 3 μA cm -2 and 20 μA cm -2 . However, heterostructures formation led to much improved photocurrents. Photocurrent densities of 151 μA cm -2 were observed for WS 2 /CdS heterostructures respectively at 1.23 V vs RHE. The enhanced improvement in photoelectrochemical performance in the case of the heterostructures could be due to the following factors: (a) the intimate interaction of this unique heterostructure improves adhesion and lowers the photoinduced charge transfer barrier; (b) increased light harvesting capability; and (c) improved charge dynamics of photoinduced charge carriers due to proper band alignment. The current study paves the way for further research into the creation of metal sulfide heterostructures that generate analogous photoelectrode materials. Keywords: Photoelectrochemical water splitting, metal sulfides, photoelectrodes. Figure 1

Recent Advances in Nanoscale Engineering of Ternary Metal Sulfide-Based Heterostructures for Photocatalytic Water Splitting Applications

Enhanced hydrogen evolution via interlaced Ni 3 S 2 /MoS 2 heterojunction photocatalysts with efficient interfacial contact and broadband absorption

Recent progress on two-dimensional van der Waals heterostructures for photocatalytic water splitting: a selective review

A review on potential sulfide-based ternary chalcogenides for emerging photo-assisted water purification applications

Photo/Electrochemical Applications of Metal Sulfide/TiO2 Heterostructures

Recent Advances in Designing ZnIn2S4-based Heterostructured Photocatalysts for Hydrogen Evolution

Metal Chalcogenides Based Heterojunctions and Novel Nanostructures for Photocatalytic Hydrogen Evolution

High solar-to-hydrogen efficiency in the novel derivatives of group-III trichalcogenides for photocatalytic water splitting: the effect of elemental composition

Enhanced Photoelectrochemical Performance in Engineered Interface 2D Metal Sulfide Heterostructures for Water Splitting

Constructing metal sulfide-based S-scheme heterojunctions for efficient photocatalytic reaction: a mini review of recent advances

Two-dimensional heterostructures for photocatalytic water splitting: a review of recent progress

Heterojunction Engineering of Multinary Metal Sulfide‐Based Photocatalysts for Efficient Photocatalytic Hydrogen Evolution

Photocatalytic Hydrogen Evolution Using Ternary‐Metal‐Sulfide/TiO 2 Heterojunction Photocatalysts

Recent Progress on Metal-Organic Frameworks Based- and Derived-Photocatalysts for Water Splitting

A compendium of all-in-one solar-driven water splitting using ZnIn2S4-based photocatalysts: guiding the path from the past to the limitless future

State-of-the-art Advancements of Transition Metal Oxides As Photoelectrode Materials for Solar Water Splitting

Two-dimensional C3N/WS2 vdW heterojunction for direct Z-scheme photocatalytic overall water splitting

Transition Metal Dichalcogenides [MX2] in Photocatalytic Water Splitting

2D materials and heterostructures for photocatalytic water-splitting: a theoretical perspective

Design of polymeric carbon nitride-based heterojunctions for photocatalytic water splitting: a review

First-Principles Study on Transition-Metal Dichalcogenide/BSe van der Waals Heterostructures: A Promising Water-Splitting Photocatalyst