Abstract:Monitoring traffic loads is vital for ensuring bridge safety and overload controlling. Bridge weigh-in-motion (BWIM) technology, which uses an instrumented bridge as a scale platform, has been proven as an efficient and durable vehicle weight identification method. However, there are still challenges with traditional BWIM methods in solving the inverse problem under certain circumstances, such as vehicles running at a non-constant speed, or multiple vehicle presence. For conventional BWIM systems, the velocity of a moving vehicle is usually assumed to be constant. Thus, the positions of loads, which are vital in the identification process, is predicted from the acquired speed and axle spacing by utilizing dedicated axle detectors (installed on the bridge surface or under the bridge soffit). In reality, vehicles may change speed. It is therefore difficult or even impossible for axle detectors to accurately monitor the true position of a moving vehicle. If this happens, the axle loads and bridge response cannot be properly matched, and remarkable errors can be induced to the influence line calibration process and the axle weight identification results. To overcome this problem, a new BWIM method was proposed in this study. This approach estimated the bridge influence line and axle weight by associating the bridge response and axle loads with their accurate positions. Binocular vision technology was used to continuously track the spatial position of the vehicle while it traveled over the bridge. Based on the obtained time–spatial information of the vehicle axles, the ordinate of influence line, axle load, and bridge response were correctly matched in the objective function of the BWIM algorithm. The influence line of the bridge, axle, and gross weight of the vehicle could then be reliably determined. Laboratory experiments were conducted to evaluate the performance of the proposed method. The negative effect of non-constant velocity on the identification result of traditional BWIM methods and the reason were also studied. Results showed that the proposed method predicted bridge influence line and vehicle weight with a much better accuracy than conventional methods under the considered adverse situations, and the stability of BWIM technique also was effectively improved. The proposed method provides a competitive alternative for future traffic load monitoring.

A bridge weigh-in-motion method of motorway bridges considering random traffic flow based on long-gauge fibre Bragg grating sensors

Statistical Analysis of Site-specific Traffic Load Using Weigh-in-Motion Data

Site-Specific Fatigue Load Spectrum for Urban Bridges

Bridge Vehicle Load Model on Different Grades of Roads in China Based on Weigh-in-Motion (WIM) Data

AI-based Modeling and Data-Driven Identification of Moving Load on Continuous Beams

Intelligent Simulation Method of Bridge Traffic Flow Load Combining Machine Vision and Weigh-in-Motion Monitoring

Multi-parameter Dynamic Traffic Flow Simulation and Vehicle Load Effect Analysis based on Probability and Random Theory

A bridge dynamic response analysis and load recognition method using traffic imaging

A Novel Vision-Based Framework for Identifying Dynamic Vehicle Loads on Long-Span Bridges: A Case Study of Jiangyin Bridge, China

Multi-lane vehicle load measurement using bending and shear strains

A computer vision-assisted method for identifying wheel loads of moving vehicles from dynamic bridge responses

Reference-free damage identification method for highway continuous girder bridges based on long-gauge fibre Bragg grating strain sensors

Incorporating Site-Specific Weigh-in-motion Data into Fatigue Life Assessment of Expansion Joints under Dynamic Vehicle Load

Automatic generation of fine‐grained traffic load spectrum via fusion of weigh‐in‐motion and vehicle spatial–temporal information

Trajectory Tracking and Load Monitoring for Moving Vehicles on Bridge Based on Axle Position and Dual Camera Vision

Characterization of the road profile and the rotational stiffness of supports in a bridge based on axle accelerations of a crossing vehicle

Multi-Lane Traffic Load Clustering Model for Long-Span Bridge Based on Parameter Correlation

A spatiotemporal distribution identification method of vehicle weights on bridges by integrating traffic video and toll station data

DYNAMIC BEHAVIOR OF THREE-SPAN CONTINOUS STONE ARCH BRIDGE MEASURED BY FIBER BRAGG GRATING (FBG) SENSORS

A hybrid virtual–real traffic simulation approach to reproducing the spatiotemporal distribution of bridge loads

Bayesian Vehicle Load Estimation, Vehicle Position Tracking, and Structural Identification for Bridges with Strain Measurement