Abstract:An experimental and computational investigation directed at understanding the role of buoyancy-driven convection during constrained melting of phase change materials (PCM) inside a spherical capsule is reported. The computations are based on an iterative, finite-volume numerical procedure that incorporates a single-domain enthalpy formulation for simulation of the phase change phenomenon. A Darcy’s Law-type porous media treatment links the effect of phase change on convection. Paraffin wax n-octadecane was constrained during melting inside a transparent glass sphere through the use of thermocouples installed inside the sphere. The melting phase front and melting fraction of the PCM are analyzed and compared with numerical solution obtained from the CFD code Fluent. Following a short period of symmetric melting due to prominence of diffusion, expedited phase change in the top region of the sphere and a wavy surface at the bottom of the PCM are observed. The computational predictions point to the strong thermal stratification in the upper half of the sphere that results from rising of the molten liquid along the inner surface of the sphere thus displacing the colder fluid. The waviness and excessive melting of the bottom of the PCM is shown to be underestimated by the experimental observation. This discrepancy is linked to the use of a support structure to hold the sphere. Measured temperature data and computational results near the bottom indicate the establishment of an unstable fluid layer that promotes chaotic fluctuations and is responsible for waviness of the bottom of the PCM. On the other hand, the comparison between the measured and computed temperatures in the top half of the sphere show the stable nature of the molten liquid layer. The computational results start to deviate from the thermocouple readings as one moves lower from the top of the sphere. This delay in predicting the melting instant is linked to the thermal stratification within the “constant temperature bath” that encloses the capsule.

Heat transfer and fluid flow in a PCM-filled enclosure: Effect of heated wall configuration

Experimental and Computational Study of Constrained Melting of Phase Change Materials (pcm) Inside A Spherical Capsule

Experimental Investigation of the Comprehensive Heat Transfer Performance of PCMs Filled with CMF in a Heat Storage Device

Investigation on the Melting Performance of a Phase Change Material Based on a Shell-and-Tube Thermal Energy Storage Unit with a Rectangular Fin Configuration

Impact of Fin Arrangement on Heat Transfer and Melting Characteristics of Phase Change Material

Study of melting behavior of phase change material in a square enclosure with constant and variable heat flux at different wall heating conditions: A numerical approach

Studies on the melting dynamics of PCM in a semicircular cavity with straight and wavy heating surfaces

Melting Performance Enhancement of Phase Change Material with Magnetic Particles under Rotating Magnetic Field

Optimizing of partial porous structure for efficient heat transfer and thermal energy storage of phase change material in a rectangular cavity

Enhancement of PCM melting rate via internal fin and nanoparticles

Scrutiny of melting rate of phase change material in a four petals cavity with internal branch fins under magnetic field

Melting and Heat Transfer Characteristics of Phase Change Material: A Comparative Study On Wire Mesh Finned Structure and Other Fin Configurations

Analysis of Melting Dynamics and Parametric Optimization in Encapsulated Phase Change Materials for Thermal Energy Storage

Unconstrained melting of phase change material in cylindrical containers inside hot water tanks: Numerical investigation and effect of aspect ratios

Numerical study on melting and heat transfer characteristics of vertical cylindrical PCM with a focus on the solid-liquid interface heat transfer rate

Comparative analysis on melting performance of PCM using rectangular and branching fin configurations in a shell and tube type thermal energy storing unit

Numerical Study on the Effect of Incorporating Phase Change Materials in a Wall

Effect of thermal parameters on heat storage and release performance of phase change material composite wall

Natural convection in the melting of PCM in a cylindrical thermal energy storage system: effects of flow arrangements of heat transfer fluid and associated thermal boundary conditions

Effect of filling configurations on melting heat transfer characteristic of phase change materials partially filled with metal foam

Temporal numerical analysis of beeswax PCM melting in a cube geometry subjected to a constant wall temperature condition