Abstract:An experimental and computational investigation directed at understanding the role of buoyancy-driven convection during constrained melting of phase change materials (PCM) inside a spherical capsule is reported. The computations are based on an iterative, finite-volume numerical procedure that incorporates a single-domain enthalpy formulation for simulation of the phase change phenomenon. A Darcy’s Law-type porous media treatment links the effect of phase change on convection. Paraffin wax n-octadecane was constrained during melting inside a transparent glass sphere through the use of thermocouples installed inside the sphere. The melting phase front and melting fraction of the PCM are analyzed and compared with numerical solution obtained from the CFD code Fluent. Following a short period of symmetric melting due to prominence of diffusion, expedited phase change in the top region of the sphere and a wavy surface at the bottom of the PCM are observed. The computational predictions point to the strong thermal stratification in the upper half of the sphere that results from rising of the molten liquid along the inner surface of the sphere thus displacing the colder fluid. The waviness and excessive melting of the bottom of the PCM is shown to be underestimated by the experimental observation. This discrepancy is linked to the use of a support structure to hold the sphere. Measured temperature data and computational results near the bottom indicate the establishment of an unstable fluid layer that promotes chaotic fluctuations and is responsible for waviness of the bottom of the PCM. On the other hand, the comparison between the measured and computed temperatures in the top half of the sphere show the stable nature of the molten liquid layer. The computational results start to deviate from the thermocouple readings as one moves lower from the top of the sphere. This delay in predicting the melting instant is linked to the thermal stratification within the “constant temperature bath” that encloses the capsule.

Analysis of Melting Dynamics and Parametric Optimization in Encapsulated Phase Change Materials for Thermal Energy Storage

Encapsulation of Phase Change Materials Via Interfacial Miniemulsion Polymerization for High Thermal Energy Storage Density

Experimental and Computational Study of Constrained Melting of Phase Change Materials (pcm) Inside A Spherical Capsule

A New Strategy for Enhanced Latent Heat Energy Storage with Microencapsulated Phase Change Material Saturated in Metal Foam

Microencapsulated Phase Change Material (MEPCM) Saturated in Metal Foam As an Efficient Hybrid PCM for Passive Thermal Management: A Numerical and Experimental Study

Investigation on the Melting Performance of a Phase Change Material Based on a Shell-and-Tube Thermal Energy Storage Unit with a Rectangular Fin Configuration

Thermo-Mechanical Analysis of Ceramic Encapsulated Phase-Change-Material (pcm) Particles

Optimization strategies of microencapsulated phase change materials for thermal energy storage

Investigation on Phase Change Behavior of Paraffin Phase Change Material in a Spherical Capsule for Solar Thermal Storage Units

An efficient method for modelling thermal energy storage in packed beds of spherically encapsulated phase change material

An experimental study of melting behavior of the phase change material in cylindrical capsules for thermal energy storage

Numerical study on melting process of Phase Change Material as thermal energy storage

Thermal performance characterization of a thermal energy storage tank with various phase change materials

Enhancing the Melting Process of Shell-and-Tube PCM Thermal Energy Storage Unit Using Modified Tube Design

Theoretical analysis of phase change heat transfer and energy storage in a spherical phase change material with encapsulation

Structure, Characterization and Thermal Properties of the Form-Stable Paraffin/High-Density Polyethylene/Expanded Graphite/Epoxy Resin Composite PCMs for Thermal Energy Storage

Thermal and mechanical performance assessment of composite (CPCM) for energy storage

Exploring the Potential of Phase Change Material for Thermal Energy Storage in Building Envelopes

Phase Change Material Microcapsules with Melamine Resin Shell Via Cellulose Nanocrystal Stabilized Pickering Emulsion In-Situ Polymerization

Optimizing the design of composite phase change materials for high thermal power density