Abstract:At present, there is a great interest in the development of new airfoils for wind turbines and high-lift wings of unmanned aerial vehicles (UAV). The requirements for such airfoils differ from conventional aircraft airfoils, because of structural reasons and extreme operating conditions. So, wind turbine airfoils operate frequently under fully separated flow when stall is used for power regulation at high wind speeds. At the same time design of airfoils for wings UAV poses the problem of availability of high-lift at low Reynolds number. Modern airfoils are to a large extent developed from numerical methods. However, the complex flow conditions such as separation at high angles of attack, laminar separation bubbles and the transition from laminar to turbulent flow are difficult to predict accurately. Hence, testing of airfoils at a two-dimensional condition is an important phase in airfoil design. The development and validation of a 2D testing facility for investigation of single and multi-element airfoils in the wind tunnel Т-102 with open test section are considered in this article. T-102 is a continuous-operation, closed-layout wind tunnel with two reverse channels. The test section has an elliptical cross-section of 4 ×2,33 m and a length of 4 m. Two big flat panels of the L × H=3 ×3,9 m size installed upright on balance frame aligned with the free stream are used for simulating two-dimensional flow in the tunnel test section. The airfoil section in the layout of a rectangular wing is mounted horizontally between flat panels with minimum gaps to ensure 2D flow conditions. The aerodynamic forces and pitch moment acting on the model were measured by wind tunnel balance. To determine boundary corrections for a new test section of wind tunnel, the experimental investigation of three geometrically similar models has been executed. The use of boundary corrections has provided good correlation of the test data of airfoil NACA 6712 with the results obtained from the wind tunnel except for lift and drag coefficient values at high angles of attack.

Design and fabrication of a wind tunnel for building aerodynamics

Development of a large recirculating boundary-layer wind tunnel

Fundamentals of Wind-Tunnel Design

Design and testing of an affordable desktop wind tunnel

Design rules for small low speed wind tunnels

A spatially optimized wind tunnel

The design of low-speed wind tunnels

Design and Performance of a Small-Scale Aeroacoustic Wind Tunnel

A new low-turbulence wind tunnel for animal and small vehicle flight experiments

Acoustic characterization and optimization of a subsonic closed loop wind tunnel

Design and Research for the Large-Caliber Low-Speed Straight-Flow Wind Tunnel Test Platform

The Development of a Closed Loop High Speed Cascade Wind Tunnel for Aerodynamic and Heat Transfer Testing at Moderate to Low Reynolds Numbers

Air flow quality analysis of an open-circuit boundary layer wind tunnel and comparison with a closed-circuit wind tunnel

Design and Construction of an Open-circuit Wind Tunnel with Specific Measurement Equipment for Cycling

Experimental and numerical analysis of a new wind tunnel for building and mechanical ventilation components performance assessment

Design and Evaluation of a Flow Capturing Device for a High-Speed Wind Tunnel

Design and characterization of a multifunctional low-speed anechoic wind tunnel at HKUST

SIMULATION OF 2D FLOW AROUND OF AIRFOILS AT LOW-SPEED WIND TUNNEL WITH OPEN JET TEST-SECTION

Low-Speed Open Return Wind Tunnel Aerodynamic Design and Numerical Calculation

The Further Research on the Design of Low(varying) Turbulence Wind Tunnel

A Wind Tunnel in Your Classroom: The Design and Implementation of a Portable Wind Tunnel for Use in the Science Classroom