Abstract:Phosphogypsum, a typical by-product in the phosphorus chemical industry, could generate a large amount of leachate containing phosphate and fluoride in the process of rainfall and long-term stacking, which not only causes serious environmental pollution, but also leads to a waste of resources. In this study, a united treatment of calcium hydroxide precipitation and lanthanum zeolite (La-ZFA) adsorption was proposed to achieve the recovery of phosphate and fluoride from phosphogypsum leachate. In phosphogypsum, most phosphorus could be leached except P in the residual occurrence form, while for fluoride, only water-soluble F could be effectively leached. The optimum leaching amounts of phosphate and fluoride were 22.59 and 4.64 mg/g, respectively, at liquid-solid ratio of 400:1, leaching time of 120 min, pH of 6.0, particle size of >200 mesh (<0.075 mm), and leaching temperature of 25°C. Using Ca(OH)2 as the precipitant, the phosphate could be precipitated selectively from phosphogypsum leachate by controlling pH and time, and the concentrations of it decreased significantly to 0.29 mg/L at pH 10.0, with a removal efficiency of 99.48%. XRD, SEM and Visual MINTEQ software analysis proved that the main component of the precipitate was hydroxyapatite (Ca5(PO4)3(OH)). After P precipitation, a series of sorbents for fluoride were investigated, and La-ZFA sorbent was chosen and utilized to recover the fluoride from the leachate through a cyclic fixed-bed column. The efficiency of La-ZFA was basically not affected by the high concentration sulfate, and it can selectively adsorb fluoride from phosphogypsum leachate, leading to a final fluoride concentration of 0.29 mg/L in the effluent. The characterization demonstrated that fluoride might be adsorbed onto the La-ZFA via ligand exchange with hydroxy groups. The proposed method in this study is expected to sequentially recover phosphate and fluorine from the leachate of phosphogypsum, and it has great guiding significance for resource utilization and management of phosphogypsum.

Simultaneous removal of Al3+, Mg2+ and F- from wet-process phosphoric acid achieved by a co-precipitation strategy

Removal of Al 3+ and Mg 2+ ions in wet-process phosphoric acid via the formation of aluminofluoride complexes

Designing an efficient fluorine recovery strategy for Wet-Process phosphoric acid purification by disclosing competitive complexation behavior between fluorine species and metal cations

Efficient and cost-effective fluorine recovery from liquid-phase wet-process phosphoric acid via two-step precipitation method

Phosphorus removal and recovery from wastewater by highly efficient struvite crystallization in an improved fluidized bed reactor

Removal of Fe(III)/Al(III)/Mg(II) by phosphonic group functionalized resin in wet-process phosphoric acid: Mechanism and intrinsic selectivity

Aluminium sulfate synergistic electrokinetic separation of soluble components from phosphorus slag and simultaneous stabilization of fluoride

Phosphorus Removal Using Ferric–calcium Complex As Precipitant: Parameters Optimization and Phosphorus-Recycling Potential

Removal of phosphorus from phosphonate-loaded industrial wastewaters via precipitation/flocculation

A Novel Fe(II)-Ca Synergistic Phosphorus Removal Process: Process Optimization and Phosphorus Recovery.

Efficient recovery of fluorine from wet-process phosphoric acid using silicon powder as a new and eco-friendly reagent

Highly Efficient Removal of Phosphonates from Water by a Combined Fe(III)/UV/co-precipitation Process.

Removal of Fluorine from Wet-Process Phosphoric Acid Using a Solvent Extraction Technique with Tributyl Phosphate and Silicon Oil

Preparation of polyphosphoric acid and recovery of valuable fluorine resources though a microwave intensification flash evaporation process

Utilization of Methyltrichlorosilane As a Novel and Efficient Reagent to Enhance Fluorine Recovery from Wet-Process Phosphoric Acid

New insights into defluoridation via induced crystallization: Implications of phosphate species regulation for process efficiency and economics

Efficient recovery of highly pure CaF2 from fluorine-containing wastewater using an icy lime solution

Highly efficient recovery of phosphate and fluoride from phosphogypsum leachate: Selective precipitation and adsorption

Fabrication of aluminum beads derived from selectively recovered Al-rich precipitates and their application into defluoridation

Development of a Polyaluminum Ferric Titanium Chloride for Phosphorous Removal in Water