Abstract:In-situ testing of the thermal transmittance of exterior walls is crucial for building energy audits, insulation retrofitting, and energy consumption monitoring. The existing testing methods suffer from drawbacks related to stringent testing conditions, time consumption, and extensive workloads. This study proposes an in-situ method for testing the thermal transmittance of exterior walls using unmanned aerial vehicle (UAV) infrared thermography (IRT). The results were validated through four in-situ tests on two buildings from different eras using a heat flow meter. The results indicated that as the testing distance was increased by the UAV, the test values for the thermal transmittance in the region of interest (ROI) on the walls gradually decreased with an increase in the number of errors. Compared with the dynamic calculation results, the minimum testing errors at a 15 m distance for the A05 and N09 apartments were 17.8 % and 5.8 %, respectively. At testing speeds of 0.5 m/s and 1.5 m/s, the changes in average temperature and heat flux at the ROI of the A05 and N09 apartments were less than 0.5 °C and 0.5 W/m 2 , respectively, and the changes in the thermal transmittance test values were less than 2 % for both. In outdoor environments with wind speeds ranging from 0.2 to 1.5 m/s, the average temperature at the ROI decreased with increasing wind speed as the heat flux increased. The testing error for the thermal transmittance at the east-facing wall of the N09 apartment ROI increased from 2.2 % to 25.2 %. In summary, under outdoor wind speeds below 0.4 m/s at 15 m from the exterior wall and with a flight speed of 0.5 m/s, the horizontal stripe flight path was found to be the most suitable for testing the wall thermal transmittance. This approach enables fast, cost-effective, and efficient monitoring of the thermal performance of building envelope structures.

Detection of Vertical Air Temperature Distribution by Long-Wave Infrared Thermography

On-site Measured Indoor Thermal Environment in Large Spaces of Airports During Winter

An automated non-contact wall temperature measurement using thermoreflectance

Temporal variation of wall flow and its influences on energy balance of the building wall

A New Method of Pixel-level In-situ U-value Measurement for Building Envelopes Based on Infrared Thermography

Infrared Thermography Diagnostics of Air Permeability Through Building Openings – Assessment of its Reliability

Reduction of Heating Energy Demand by Combining Infrared Heaters and Infrared Reflective Walls

Evaluation of building materials using infrared thermography

Remote sensing of indoor thermal environment from outside the building through window opening gap by using infrared camera

An in-situ detection method for assessing the thermal transmittance of building exterior walls using unmanned aerial vehicle–infrared thermography (UAV-IRT)

Infrared thermography for building diagnostics

Active IR-applications in civil engineering

Quantitative thermography for the estimation of the U-value: state of the art and a case study

Quantitative internal infrared thermography for determining in-situ thermal behaviour of façades

Building defects diagnosis by infrared thermography

Thermographic cameras for thermal comfort applications: simulated and experimental spectral response errors of various long-wave infrared detectors

Estimating Indoor Air Temperature by Obtaining Outdoor Building Window Surface Temperature Using Infrared Technology: an Exploratory Approach

Performance Investigation of Convective and Radiant Heat Removal Methods in Large Spaces

Non-Destructive Possibilities of Thermal Performance Evaluation of the External Walls

Infrared thermography in the built environment: A multi-scale review

Portable recording system for spherical thermography and its application to longwave mean radiant temperature estimation