Abstract:The freezing damage of rock tunnels in cold region involves ice-water phase change and complicated interaction of Thermo–Hydro–Mechanical (THM) field. Taking the fractured rock mass of cold region tunnels as research subject, the THM coupling model of cold region tunnels was established, which is based on the seepage mechanics, heat transfer theory, damage mechanics and equivalent continuum theory. This model could reflect the anisotropic properties of deformation, water migration and heat transfer caused by the initial fracture of rock mass. The construction and operation processes of a rock tunnel in cold region were simulated, and results were compared with the measured value and predecessor's achievements. It shows that proposed model could reflect the anisotropic property of surrounding rock and the simulated deformation and stress are not symmetrical. Compared with the literature, the calculated results in this paper are closer to the measured values. The insulating layer has a significant effect on the stress of the supporting structures. The maximum tension stress of the lining is 4.5 times as that without insulating layer, and the lining will be destroyed for the overlarge tension stress.

What problem does this paper attempt to address?

The paper primarily aims to address the issue of freeze-thaw damage in rock tunnels in cold regions caused by ice-water phase transitions during construction and operation. Specifically: 1. **Research Background**: The paper points out that approximately 50% of the world's land area is located in permafrost regions, where unique climatic conditions pose challenges to engineering construction. For example, the Yuximolegai Tunnel (National Highway 217 in Xinjiang, China) was abandoned due to freeze-thaw damage, the Guanjiao Tunnel on the Qinghai-Tibet Railway experienced heaving in winter and mud eruptions in summer. Additionally, tunnels in Japan and Norway also suffer from varying degrees of freeze-thaw damage. 2. **Research Objectives**: To better understand and address the aforementioned issues, the researchers developed a thermal-hydraulic-mechanical (THM) coupling model suitable for rock tunnels in cold regions. This model considers the anisotropic characteristics caused by initial rock fractures, can simulate deformation and stress distribution during construction and operation phases, and assesses the impact of insulation layers on the stress of support structures. 3. **Model Application**: The effectiveness of the proposed THM model was validated through numerical simulation experiments on the entrance section of the Kunlun Mountain Tunnel on the Qinghai-Tibet Railway. The results showed that compared to the case without an insulation layer, a 5 cm thick insulation layer can significantly reduce the melting depth of the surrounding rock and make the simulated deformation and stress values closer to actual measured data. However, after 10 years of operation, the presence of the insulation layer would increase the maximum tensile stress of the lining structure to 4.5 times that without the insulation layer, which could lead to lining damage. In summary, this paper aims to provide theoretical basis and technical support for the design and construction of rock tunnels in cold regions by establishing a THM coupling model that considers ice-water phase transitions and anisotropy.

THM model of rock tunnels in cold regions and numerical simulation

A TOUGH-FEMM based cryogenic THM coupled model and its application to cold-region tunnels

A fully coupled thermo-hydro-mechanical model for fractured rock masses in cold regions

Study Of Surrounding Rock Damage Induced By Tunnel Boring Machine Driving Tunnel At West Route Of South To North Water Transfer Project

Investigation of hydro-thermal variations and mechanical properties in cold region tunnels under long-term freeze–thaw cycles

Analytical solution for surrounding rock temperature of cold-region tunnel considering phase change

Damage Characteristics of Limestone under Freeze–Thaw Cycle for Tunnels in Seasonal Frozen Areas

Change of temperature field around different drainage structures in cold region tunnel based on model testing

Experimental Study on the Temperature Field of Cold Region Tunnel under Various Groundwater Seepage Velocities

Mechanical analysis of frost heaving of weakly cemented soft rock tunnels in cold regions

Study on the Freeze-Thaw Process of the Lining Structures of a Tunnel on Qinghai-Tibet Plateau with the Consideration of Lining Frost Damage

Numerical Investigation of Heat-Insulating Layers in a Cold Region Tunnel, Taking into Account Airflow and Heat Transfer

Study on Temperature Distribution Law of Tunnel Portal Section in Cold Region Considering Fluid–Structure Interaction

Evolution Characteristics of Plastic Zone in Jointed Rock Mass of High-Temperature Hydraulic Tunnel

Model test on frost heaving pressure induced by frozen partial ponding behind tunnel lining in cold region

An Analytical Solution for the Frost Heaving Force considering the Freeze-Thaw Damage and Transversely Isotropic Characteristics of the Surrounding Rock in Cold-Region Tunnels

A Fully Thermo-Hydro-Mechanical Coupling Simulation at Low Temperature in Underground LNG Storage

Evolution Patterns of Frost-Heaving Pressure with Partial Ponding in Cold Region Tunnels

Study on the Progressive Deterioration of Tunnel Lining Structures in Cold Regions Experiencing Freeze–Thaw Cycles

Experimental and Analytical Study on Mechanical Properties of High Rock Temperature Diversion Tunnel

An Analytical Solution of Frost Heaving Pressure for Cold-region Tunnel Considering Freeze-thaw Cycles and in-situ Stress