Development of an antimicrobial, 3D printable denture base material with K18 quaternary ammonium silane-functionalized methyl methacrylate and filler
Mansi Patel,Leslie Barrera,Lianrui Chu,Kyumin Whang
DOI: https://doi.org/10.1016/j.prosdent.2024.03.013
IF: 4.148
2024-03-25
Journal of Prosthetic Dentistry
Abstract:Statement of problem Denture base materials are highly susceptible to microbial colonization, which can lead to denture stomatitis. In addition, patients who sleep with their dentures have an increased chance of contracting pneumonia. Commercially available antimicrobial denture base materials to prevent or combat microbial colonization are lacking. Purpose The purpose of this in vitro study was to determine the effects of K18 quaternary ammonium methacryloxy silane-functionalized filler (K18-Filler) and methyl methacrylate (K18-MMA) on the polymerization of 3D printed denture base material and its esthetic, mechanical, and antimicrobial properties. Material and methods K18-Filler (0%, 10%, 20% w/w) and K18-MMA (0%, 5%, 12.5% w/w) were added to a 3D printable denture base resin (Denture Base Resin, Original Pink; Formlabs Inc.) and 3D printed. Specimens were tested by using the Rockwell 15T hardness, near infrared FTIR monomer-to-polymer degree of conversion (DoC), transparency parameter (TP), color shift, and 3-point bend and by counting colony forming units against Streptococcus aureus, Streptococcus sanguinis and Candida albicans tests. Data were analyzed using analysis of variance with the Tukey-Kramer HSD post hoc test. Results Control resins had significantly higher Rockwell 15T hardness than most of the K18 groups ( P <.05) but had comparable DoC with all K18 groups except one, showing that all groups were well polymerized. Controls had significantly higher TP than most K18 groups, but most K18 groups had ΔE 8. All K18 groups had comparable or greater moduli than the controls, but the controls had significantly higher ultimate transverse strengths than most K18 groups ( P <.05). All 12.5% K18-MMA with K18-Filler groups had significant antimicrobial activity against S. aureus , S. sanguinis , and C. albicans . Conclusions 12.5% K18-MMA and K18-Filler produced 3D printable denture materials with comparable polymerization properties and significant antimicrobial properties against S. mutans , S. sanguinis , and C. albicans . High K18-MMA and K18-Filler concentrations caused significant color shifts and reductions in ultimate strengths.
dentistry, oral surgery & medicine